Sage Journals: Discover world-class research

Abstract

The jet flow at the orifice produced by a cavity-pumping device is studied in the present paper. Internal instantaneous pressure is obtained using analytical solution based on assumptions of isothermal condition and incompressible flow. An example of a venting of a cylindrical cavity with initial volume 1.59 × 10⁻⁵ m³ and orifice area 1.96 × 10⁻⁵ m² is considered to determine the differential pressure across the orifice under the sinusoidal variation of the cavity volume. Variation of maximum pressure jump across the orifice as function of angular frequency is obtained for a given cavity volume ratio. The analytical solution of time-dependent volume of incompressible flow retains all the geometrical parameters of the synthetic jet actuator, therefore, can be employed to validate numerical solution of compressible flow under the isothermal condition.

Keywords

venting incompressible flow orifice synthetic jet actuator

Get full access to this article

View all access options for this article.

References

Seifet

Pack

L. G.

Active control of separated flows on generic configurations at high Reynolds number. AIAA paper 99–3403, 1999.

C.-H.

Tai

Y.-C.

Review: MEMS and its application flow controls. J. Fluids Eng., 1996, 118 (3), 437–447.

Jacobson

S. A.

Reynolds

W. C.

An experimental investigation towards the active control of turbulent boundary layers. Report no. TF-64, Thermosciences Divisions, Department of Mechanical Engineering, Stanford University, Stanford, CA, 1995.

Lin

Y.-L.

Chyu

M. K.

Shih

T. I.-P

Skin friction reduction through micro blowing. AIAA paper 98–0359, 1995.

Parker

J. D.

Boggs

J. H.

Blick

E. F.

Introduction to fluid mechanics and heat transfer, 1974, p. 302 (Addison-Wesley Publishing Co., USA).

Tang

Zhong

2D numerical study of circular synthetic jets in quiescent flow. Aeronaut. J., 2005, 109 (1092), 89–97.

Jabbal

Zhong

The performance of round synthetic jets in quiescent flow. Aeronaut. J., 2006, 110 (1108), 385–393.

White

F. M.

Fluid mechanics, 1979 (McGraw-Hill, New York).

Blevins

R. D.

Applied fluid dynamics handbook, 1984, pp. 71–143 (Van Nostrand Reinhold, New York, USA).

Analytical solution for venting from a time-dependent cavity volume

Abstract

Abstract

Keywords

Get full access to this article

References