Transition detection for laminar flow aircraft using microphones beneath the surface of laser drilled suction panels

Abstract

The possibility of detecting transition through the very small laser drilled perforations in panels representing the suction surface of a hybrid laminar flow aircraft is examined. The method uses miniature microphones to detect changes to the noise received from the boundary layer. Tests using a flat plate rig in a low-turbulence wind tunnel at Reynolds numbers up to 3.8 million per metre, demonstrate that the boundary layer state can be defined in this manner, most simply through measurement of the root mean square (r.m.s.) of the microphone signal. It is shown that the r.m.s. reaches a peak in the transition zone and that when the boundary layer is fully turbulent the value is still significantly higher than it was before transition. Porosity in the range 0.8-6.4 percent was examined, with nominal hole diameters of 0.06 and 0.10 mm in 0.9 mm thick laser drilled suction surface specimens. Suction flow through the surface was found not adversely to affect the operation of the system.

The experiment was limited to low Reynolds numbers because the high background noise in the wind tunnel made detection of the boundary layer element of the signal increasingly difficult to define as speed increased. It is considered that test in flight will be needed to prove fully the validity of the method. A preliminary design of an installation for this purpose is suggested that allows the suction flow to be maintained over the measuring region.

Keywords

laminar flow transition detection boundary layer suction microphone

Get full access to this article

View all access options for this article.

References

Pfenninger

Comparison of the momentum method with balance measurements. Mitteilung No. 8, Institute of Aerodynamics, ETH Zurich, 1943.

Raspet

Boundary layer studies on a sailplane. Aeronaut. Engng Rev., 1952, 2 (6).

Pfenninger

Groth

Boundary layer suction experiments in flight on an F-94 airplane with suction through a large number of fine slots. In Boundary Layer and Flow Control (Ed. Lachmann

G. V.

), 1961, vol. 2, pp. 1007–1032 (Pergamon Press).

Barrett

R. V.

Rickards

Investigation of acoustic transition detection, including flight measurements. In Proceedings of Boundary Layer Transition and Control Conference, Cambridge, April 1991.

Rickards

Barrett

R. V.

Development of an acoustic transition detector with application to boundary layer control by suction. In Proceedings of 1st European Forum on Laminar Flow Technology, Hamburg, March 1992.

Barrett

R. V.

Rickards

Swales

Analysis of data from boundary layer transition sensors in the Elfin S1MA wind tunnel tests with supporting work from LARA task 1.3 (Final Technical Report—LARA Subtask 1.1). LARA Report LTR24, University of Bristol, Department of Aerospace Engineering, Report 708, March 1995.

Barrett

R. V.

Kuhn

Anwendung eines traversierbaren Mikrofonarrays zur Untersuchung einer gestorten laminaren Grenzschicht an abgesaugten feinperforierten Blechen. Proc. Flachige Stromungsmessverfahren, Institut für Luftund Raumfahrt, TU Berlin, March 1995, ILR-Mitteilung, 1995.

Nelson

P. A.

Tutty

O. R.

Wright

M. C. M.

Allen

Rogers

Strategies for the automatic control of laminar boundary layer transition. In Proceedings of 2nd European Forum on Laminar Flow Technology, Bordeaux, June 1996 (AAAF, Paris).

Barrett

R. V.

Design and performance of a new low turbulence wind tunnel at Bristol University. Aeronaut. J., March 1984, 86–90.