An investigation and evaluation of variable-valve-timing and variable-valve-actuation strategies in a diesel homogeneous charge compression ignition engine using three-dimensional computational fluid dynamics

Abstract

A three-dimensional computational fluid dynamics modelling was carried out to investigate effects of variable valve timing (VVT) and variable valve actuation (VVA) on gas exchange and fuel-air mixing processes in a diesel homogeneous charge compression ignition (HCCI) engine with early fuel injection. Four VVT or VVA strategies were conducted for this study: first, a negative valve overlap (NVO) strategy with fixed exhaust-valve-opening (EVO) and intake-valve-closing (IVC) timings but variable valve lifts, referred to as the NVO strategy; second, the NVO strategy with fixed valve profiles but variable EVO and IVC timings, referred to as the EVO strategy; third, the NVO strategy with fixed valve lifts and fixed EVO and IVC timings but variable exhaust-valve-closing (EVC) and intake-valve-opening timings, referred to as the EVC strategy; fourth, VVA with just variable valve lifts, referred to as the VMAX strategy. The results indicate that suitable NVO settings will enhance in-cylinder tumble and then increase turbulence intensity before compression end, although the increased NVO has a negative contribution to swirl ratio. It was found that reducing valve lifts alone is not an efficient way to retain the residual gas, but the function of reduced valve lifts will become significantly obvious by combining it with increasing NVO. For the effect of NVO on in-cylinder temperature, longer NVO not only will increase in-cylinder temperature because of the higher residual gas rate but also will improve the in-cylinder temperature homogeneity. On lowering the maximum valve lift or increasing the NVO, the unmixed region of the in-cylinder charge shrinks. The fuel-rich region expands because of the high intake velocity and enhanced turbulence intensity. This is beneficial to the forming of a global homogeneous charge. It has been noted from the current study that, as the droplet distribution may be influenced more by the in-cylinder air motion caused by NVO when the average droplet size is smaller, it is recommended that future studies explore the effects of VVT and VVA on diesel HCCI mixing and combustion with various advanced fuel injection strategies.

Keywords

homogeneous charge compression ignition combustion diesel engine variable valve timing variable valve actuation negative valve overlap computational fluid dynamics KIVA-3V

Get full access to this article

View all access options for this article.

References

Coma

Gastaldi

HCCI: A combustion for the future? Int. J. Veh. Des., 2006, 41, 18–31.

Atkins

M. J.

Koch

C. R.

The effect of fuel octane and dilutent on homogeneous charge compression ignition combustion. Proc. IMechE Part D: J. Automobile Engineering, 2005, 219, 665–675.

Wang

J.-X.

Shuai

S.-J.

Tian

G.-H.

X.-L.

Q.-J.

Study of the effect of spark ignition on gasoline HCCI combustion. Proc. IMechE Part D: J. Automobile Engineering, 2006, 220, 817–825.

Simescu

Fiveland

S. B.

Dodge

L. G.

An experimental investigation of PCCI-DI combustion and emissions in a heavy-duty diesel engine. SAE Paper 2003–01–0345, 2003.

Strandh

Bengtsson

Johansson

Tunestal

Johansson

Cycle-to-cycle control of a dual-fuel HCCI engine. SAE Paper 2004–01–0941, 2004.

Yap

Megaritis

Wyszynski

M. L.

An investigation into bioethanol homogeneous charge compression ignition (HCCI) engine operation with residual gas trapping. Energy Fuels, 2004, 18, 1315–1323.

Helmantel

Denbratt

HCCI operation of a passenger car DI diesel engine with an adjustable valve train. SAE Paper 2006–01–0029, 2006.

Fuerhapter

Unger

Piock

W. F.

Fraidl

G. K.

The new AVL CSI engine - HCCI operation on a multi cylinder gasoline engine. SAE Paper 2004–01–0551, 2004.

Caton

P. A.

Song

H. H.

Kaahaaina

N. B.

Edwards

C. F.

Residual-effected homogeneous charge compression ignition with delayed intake-valve closing at elevated compression ratio. Int. J. Engine Res., 2005, 6(4), 399–419.

10.

Murata

Kawano

Kusaka

Daisho

Suzuki

Ishii

Goto

Odaka

Achievement of medium engine speed and load premixed diesel combustion with variable valve timing. SAE Paper 2006–01–0203, 2006.

11.

Shi

Deng

Cui

Study of diesel-fuelled homogeneous charge compression ignition combustion by in-cylinder early fuel injection and negative valve overlap. Proc. IMechE Part D: J. Automobile Engineering, 2005, 219, 1193–1201.

12.

Mahrous

A. F. M.

Wyszynski

M. L.

Wilson

H. M.

Computational fluid dynamics simulation of in-cylinder flows in a motored homogeneous charge compression ignition engine cylinder with variable negative valve overlapping. Proc. IMechE Part D: J. Automobile Engineering, 2007, 221, 1295–1304.

13.

Caton

P. A.

Song

H. H.

Kaahaaina

N. B.

Edwards

Strategies for achieving residual-effected homogeneous charge compression ignition using variable valve. SAE Paper 2005–01–0165, 2005.

14.

Leet

J. A.

Simescu

Froelund

Dodge

L. G.

Roberts

C. E.

Emissions solutions for 2007 and 2010 heavy-duty diesel engines. SAE Paper 2004–01–0124, 2004.

15.

Fessler

Genova

An electro-hydraulic ‘lost motion’ VVA system for a 3.0-liter diesel engine. SAE Paper 2004–01–3018, 2004.

16.

Nevin

R. M.

Sun

Gonzalez

M. A.

Reitz

R. D.

PCCI investigation using variable intake valve closing in a heavy duty diesel engine. SAE Paper 2007–01–0903, 2007.

17.

Kodama

Nishizawa

Sugihara

Sato

Iijima

Yoshida

Full-load HCCI operation with variable valve actuation system in a heavy-duty diesel engine. SAE Paper 2007–01–0215, 2007.

18.

Parvate-Patil

G. B.

Gordon

H. H.

Analysis of variable valve timing events and their effects on single cylinder diesel engine. SAE Paper 2004–01–2965, 2004.

19.

Amsden

A. A.

KIVA-3V: a block-structured KIVA program for engines with vertical or canted values. Report LA-13313-MS, Los Alamos National Laboratory, Los Alamos, New Mexico, USA, 1997.

20.

Han

Z. W.

Reitz

R. D.

Turbulence modeling of internal combustion engines using RNG k- models. Combust. Sci. Technol., 1995, 106, 267–295.

21.

Kim

Reitz

R. D.

Liechty

M. P.

Application of micro-genetic algorithms for the optimization of injection strategies in a heavy-duty diesel engine. SAE Paper 2005–01–0219, 2005.

22.

Juneja

Reitz

R. D.

Optimization of injection rate shape using active control of fuel injection. SAE Paper 2004–01–0530, 2004.

23.

Jia

Xie

Numerical simulation of homogeneous charge compression ignition combustion using a multi-dimensional model. Proc. IMechE Part D: J. Automobile Engineering, 2007, 221, 465–480.

24.

Lechner

G. A.

Jacobs

Chryssakis

Assanis

D. N.

Siewert R

Evaluation of a narrow spray cone angle, advanced injection timing strategy to achieve partially premixed compression ignition combustion in a diesel engine. SAE Paper 2005–01–0167, 2005.

25.

Urushihara

Hiraya

Kakuhou

Itoh

Expansion of HCCI operating region by the combination of direct fuel injection, negative valve overlap and internal fuel reformation. SAE Paper 2003–01–0749, 2003.

26.

Wilson

Haste

Richardson

Yap

Megaritis

In-cylinder flow with negative valve overlapping - characterized by PIV measurement. SAE Paper 2005–01–2131, 2005.

27.

Jhavar

Rutland

C. J.

Effects of mixing on early injection diesel combustion. SAE Paper 2005–01–0154, 2005.

28.

Heywood

Internal combustion engine fundamentals, 1988 (McGraw-Hill, New York).