New ignition sources are needed to operate the next generation of lean high-efficiency internal combustion engines. A significant environmental and economic benefit could be obtained from these lean engines. Towards this goal, the quarter wave coaxial cavity resonator (QWCCR), igniter was examined. A brief overview of the QWCCR's history is presented, followed by an electromagnetic analysis of the resonator. Microwave and radio-frequency gas breakdown at atmospheric and higher conditions are reviewed briefly. The presented analysis focuses on geometric and material parameter relations compared with performance characteristics, such as resonator quality factor and developed tip electric field which initiates a single-electrode high-pressure microwave gas breakdown. Conductor surface losses, dielectric losses, and radiation losses of the device are considered in the analysis, for which parameters of a prototype QWCCR were chosen for construction and evaluation of a resonator. Improved designs allowed successful integration of a QWCCR into a Briggs and Stratton engine. Given the capability of precise control, high power, and high energy delivery, and the opportunity for further optimization, the QWCCR has the potential to deliver more energy per ignition than a conventional spark plug and thus should be considered for application as a lean ignition source.
DaleJ. D.CheckelM. D.SmyP. R.‘Application of high energy ignition systems to engines.’Prog. Energy Combust. Sci.23 (1997): 379–398.
2.
MalyR.SaggauB.WagnerE.ZiglerG.‘Prospects of ignition enhancement.’ SAE paper 830478, 1983.
3.
RagerJ.Funkenerosion an Zündkertzenelectroden [Spark erosion of spark plug electrodes] PhD Dissertation, University of the Saarland, Stuttgart, Germany, 2006.
4.
MalyR.‘Spark ignition: its physics and effect on the internal combustion engine.’ In Fuel economy in road vehicles powered by spark ignition engines (Eds J. C. Hillard and G. S. Springer), 1984, ch. 3, p. 91 (Plenum, New York).
5.
McMillianM.RichardsonS.WoodruffS. D.McIntyreD.‘Laser-spark ignition testing in a natural gas-fueled single-cylinder engine.’ SAE paper 2004-01-0980, 2004.
6.
PancheshnyiS.LacosteD. A.BourdonA.LauxC. O.‘Ignition of propane–air mixtures by a repetitively pulsed nanosecond gas discharge.’IEEE Trans. Plasma Sci.34 (6) (2006): 2478–2487.
7.
AnikinN. B.MintoussovE. I.PancheshnyiS. V.RoupassovD. V.SychV. E.StarikovskiiA. Yu.‘Nonequilibrium plasma and its application for combustion and hydrosonics and hypersonic flow control.’ In Proceedings of the 41st AIAA Aerospace Science Meeting and Exhibit, Reno, Nevada, USA, 2003, AIAA paper 2003–1053.
8.
ChintalaN.BaoA.LouG.AdamovichI. V.‘Measurement of combustion efficiency in nonequilibrium RF plasma-ignited flows.’Combust. Flame144 (2006): 744–756.
9.
BerezhetskayaN. K.GritsininS. I.Kop'evV. A.KossyoeI. A.van WieD.‘Microwave discharge as a method for igniting combustion in gas mixtures.’ In Proceedings of the 43rd AIAA Aerospace Sciences Meeting and Exhibit, Reno, Nevada, USA, 2005, AIAA paper 2005–0991.
10.
LeonovA. B.YarantsevD. A.NapartovichA. P.KochetovI. V.‘Plasma-assisted ignition and flame holding in high-speed flow.’ In Proceedings of the 44th AIAA Aerospace Sciences Meeting and Exhibit, Reno, Nevada, USA, 2006, AIAA paper 2006–563.
11.
NashM. A.The coaxial cavity resonator and R.F. power processing Master Thesis, West Virginia University, Morgantown, West Virginia, USA, 1988.
12.
BonazzaT. J.Van VoorhiesK. L.SmithJ. E.‘RF plasma ignition system concept for lean burn internal combustion engines.’ In Proceedings of the 27th Intersociety Energy Conversion Engineering Conference, San Diego, California, USA, 3–7 August 1992, pp. 4.315–4.319 (SAE International, Warrendale, Pennsylvania).
13.
StilesR. D.ThompsonG. J.SmithJ. E.‘Investigation of a radio frequency plasma ignitor for possible internal combustion engine use.’ SAE paper 970071, 1971.
14.
McIntyreD. L.The coaxial cavity resonator as a prototype RF IC engine ignition source Masters Thesis, West Virginia University, Morgantown, West Virginia, USA, 2000.
15.
PertlF. A.SmithJ. E.‘Feasibility of pulsed microwave plasma ignition for use in SI-engines.’ In Proceedings of the ASME International Combustion Engine Division 2007 Fall Technical Conference, Charleston, South Carolina, USA, 14–17 October 2007, paper ICEF2007–1776 (ASME, New York).
16.
PertlF. A.LoweryA. D.SmithJ. E.‘Investigation of wire grid modeling in NEC applied to determine resonant cavity quality factors.’Appl. Comput. Electromagn. Soc. J.22 (3) (2007): 420–423.
17.
PertlF. A.SmithJ. E.‘High-level modeling of an RF pulsed quarter wave coaxial resonator with potential use as an SI ignition source.’ SAE paper SP-2180, 2008.
18.
WilhelmJ. P.PertlF. A.WildfireP. E.SmithJ. E.‘Ignition energy testing of the quarter wave coaxial cavity resonator with air–liquefied-gas mixtures.’ In Proceedings of the 39th AIAA Plasmadynamics and Laser Conference, Seattle, Washington, USA, 2008, AIAA paper 2008–3775(American Institute of Aeronautics and Astronautics, Reston, Virginia).
19.
Van VoorhiesK. L.BonassaT. L.SmithJ. E.‘Analysis of RF corona discharge plasma ignition.’ InTechnology for energy efficiency in the 21st century, Proceedings of the 27th Intersociety Energy Conversion Engineering Conference, San Diego, California, USA, 1992, SAE paper 929502, pp. 4.327–4.334 (SAE International, Warrendale, Pennsylvania).
20.
LoweryA. L.PertlF. A.SmithJ. E.‘Numerical investigation of the quarter wave coaxial cavity resonator quality factor through wire grid modeling in NEC.’ In Proceedings of the 22nd Annual Review of Progress in Applied Computational Electromagnetics, Miami, Florida, USA, 12–16 March 2006, pp. 659–663 (Applied Computational Electromagnetics Society, Monterey, California).
21.
LoweryA. D.An experimental and computational investigation of dielectrics for use in quarter wave coaxial cavity resonators Master Thesis, West Virginia University, Morgantown, West Virginia, USA, 2006.
WooR.‘Final report on RF voltage breakdown in coaxial transmission lines.’ NASA Technical Report 32–1500, Jet Propulsion Laboratory, California Institute of Technology, Pasadena, California, USA, for National Aeronautics and Space Administration, 1970.
25.
MacDonaldA. D.GaskellD. U.GittermanH. N.‘Microwave breakdown in air, oxygen, and nitrogen.’Phys. Rev.130 (5) (1963): 1841–1850.
26.
TomalaR.Microwave breakdown in air-filled waveguides and resonators Thesis, Chalmers University of Technology, Göteborg, Sweden, 2005.
27.
QuilesC. P. V.Passive intermodulation and corona discharge for microwave structures in communications satellites Dissertation, Technische Universität Darmstadt, Darmstadt, Germany, 2005.
28.
MacDonaldA. D.Microwave breakdown in gases (John Wiley1966).
29.
AndersonD. G.LisakM.LewinP. T.‘Thermal lowering of the threshold for microwave breakdown in air-filled waveguides.’IEEE Trans. Microwave Theory and Techqs35 (7) (1987): 653–656.
30.
StilesR. D.SmithJ. E.‘Modeling the radio frequency coaxial cavity plasma igniter as an internal combustion engine ignition system.’ SAE paper 980168, 1998.
31.
Von HagenJ.VenotY.WiesbeckW.‘Microwave-generated plasma in air under standard conditions.’IEEE Trans. Plasma Sci.29 (4) (2001): 604–608.
32.
LinkenheilK.RuossH. O.HeinrichW.‘Design and evaluation of a novel spark-plug based on a microwave coaxial resonator.’ In Proceedings of the 34th European Microwave Conference, Amsterdam, The Netherlands, 11–15 October 2004, vol. 3, pp. 1561–1564 (IEEE, New York).
33.
IkedaY.NishiyamaA.WachiY.KanekoM.‘Research and development of microwave plasma combustion engine (Part I: concept of plasma combustion and plasma generation technique).’ SAE paper 09PFL-0771, 2009.
34.
IkedaY.HirokiK.JeonjM.KanekoH.‘Research and development of microwave plasma combustion engine (Part II: engine performance of plasma combustion engine).’ SAE paper 09PFL-0774, 2009.
