A detailed analytical non-linear dynamic model for single-cylinder diesel engines is developed. The model describes the dynamic behaviour between fuelling and engine speed and includes models of the non-linear engine and dynamometer dynamics, the instantaneous friction terms and the engine thermodynamics. The model operates in the crank angle domain. The dynamometer model enables the study of the engine behaviour under loading. The instantaneous friction model takes into consideration the viscosity variations with temperature. Inertia variations with piston pin offset are presented. In-cycle calculations are performed at each crank angle, and the correct crank angles of ignition, speed variations, fuel supply and air as well as fuel burning rate are predicted. The model treats the cylinder strokes and the manifolds as thermodynamic control volumes by using the filling and emptying method. The model is validated using experimentally measured cylinder pressure and engine instantaneous speeds, under transient operating conditions, and gives good agreement. The model can be used as an engine simulator to aid diesel engines control system design and fault diagnostics.
LedgerJ. D.WalmsleyS.Computer simulation of a turbocharged diesel engine operating under transient load conditions. SAE paper 710177, 1971.
2.
WinterboneD. E.ThiruarooranC.WellsteadP. E.A wholly dynamic model of turbocharged diesel engine for transfer function evaluation. SAE paper 770124, 1977.
3.
BownsD. E.CaveP. R.HargreavesM. R. O.WallaceF. J.Transient characteristics of turbocharged diesel engines. Proc. Instn Mech. Engrs, CP15, 1973.
4.
WatsonN.JanotaM. S.Turbocharging the Internal Combustion Engine, 1982 (Macmillan, London).
5.
HeywoodJ. B.Internal Combustion Engine Fundamentals, 1988 (McGraw-Hill, New York).
6.
AssanisD.AtreyaA.BorgnakkeC.DowlingD.FilipiZ.HoffmanS.HomsyS.KanafaniF.MorrisonK.PattersonD.SyrimisM.WintonD.ZhangG.BryzikW.Development of a modular, transient, multi-cylinder diesel engine simulation for system per-formance and vibration studies. In Proceedings of Technical Conference of ASME ICE, Colorado, 1997, paper 97-ICE-11, pp. 87–101.
7.
RakopoulosC. G.GiakoumisE. G.Simulation and exergy analysis of transient diesel-engine operation. Energy, 1997, 22(9), 875–885.
8.
JensenJ.-P.KristensenA. F.SerensonS. C.HoubakN.HendricksE.Mean value modeling of a small turbocharged diesel engine. SAE paper 910070, 1991.
9.
WatsonN.Dynamic turbocharged diesel engine simulator for electronic control system development. Trans. ASME, J. Dynamic Systems, Measmt, Control, 1984, 106, 27–45.
10.
GissingerG. L.RenardR.HassenforderM.Model based design and control of diesel engines. SAE paper 890568, 1989.
11.
KaoM.MoskwaJ. J.Turbocharged diesel engine modelling for nonlinear engine control and state estimation. Trans. ASME, J. Dynamic Systems, Measmt, Control, 1995, 117, 20–30.
12.
FilipiZ. S.AssanisD. N.A non-linear, transient, single-cylinder diesel engine simulation for predictions of instantaneous engine speed and torque. In Proceedings of Technical Conference of ASME ICE, Colorado, 1997, paper 97-ICE-8, pp. 61–70.
13.
LiuH.ChalhoubN. G.HeneinN.Simulation of a single cylinder diesel engine under cold start conditions using SIMULINK. In Proceedings of Technical Conference of ASME ICE, Colorado, 1997, paper 97-ICE-2, pp. 9–18.
14.
ZhangY.RizzoniG.An on-line indicated torque estimator for IC engine diagnosis and control. Trans. ASME, J. Adv. Automot. Technol., 1993, 52, 147–162.
15.
RizzoniG.ZhangY.Identification of a non-linear internal combustion engine model for on-line indicated torque estimation. Mech. Systems Signal Processing, 1994, 8(3), 275–287.
16.
RizzoniG.Estimate of indicated torque from crankshaft speed fluctuations: A model for the dynamic of the IC engine. IEEE Trans. Veh. Technol., 1989, 38(3), 168–179.
17.
CitronS.O'HigginsJ.ChenL.Cylinder by cylinder engine pressure torque waveform determination utilizing crankshaft speed fluctuation. SAE paper 890486, 1989.
SIMULINK: A Program for Simulating Dynamic Systems, 1999 (MathWorks, Natick, Massachusetts).
20.
ZweiriY. H.WhidborneJ. F.SeneviratneL. D.Dynamic simulation of a single-cylinder diesel engine including dynamometer modelling and friction. Proc. Instn Mech. Engrs, Part D, Journal of Automobile Engineering, 1999, 213(D4), 391–402.
21.
ZweiriY. H.WhidborneJ. F.SeneviratneL. D.Instantaneous friction components model for transient engine operation. Proc. Instn Mech. Engrs, Part D, Journal of Automobile Engineering, 2000, 214(D7), 809–824.
22.
ZweiriY. H.WhidborneJ. F.SeneviratneL. D.A mathematical transient model for the dynamics of a single cylinder diesel engine. In Proceedings of Simulation 1998, York, September 1998, pp. 145–151.
23.
WangY.-Y. W.KrishnaswamiV.RizzoniG.Event based estimation of indicated torque for IC engines using sliding mode observers. Control Engng Practice, 1997, 5(8), 1123–1129.
LiH.StoneB. J.Time domain modelling of a reciprocating engine. Mech. Systems Signal Processing, 1999, 13(1), 169–178.
26.
DrewS. J.HestermanD. C.StoneB. J.The torsional excitation of variable inertia effects in a reciprocating engine. Mech. Systems Signal Processing, 1999, 13(1), 125–144.
27.
HestermanD. C.StoneB. J.A system approach to the torsional vibration of multi-cylinder reciprocating engines and pumps. Proc. Instn Mech. Engrs, Part C, Journal of Mechanical Engineering Science, 1994, 208(C6), 395–408.
28.
RamosJ. I.Internal Combustion Engine Modeling, 1989 (Hemisphere, New York).
29.
BormanG.NishiwakiK.A review of internal combustion engine heat transfer. Prog. Energy Combust. Sci., 1987, 13, 1–46.
30.
AssanisD. N.HeywoodJ. B.Development and use of a computer simulation of the turbocompounded diesel system for engine system for engine performance component heat transfer studies. SAE paper 860329, 1986.
31.
ZhangY.PhaneufK.HansonR.ShowalterN.Computer modeling on exhaust system heat transfer. SAE paper 920262, 1992.
32.
OzisikM. N.Heat Transfer: A Basic Approach, 1985 (McGraw-Hill, New York).
