An approximate equation for accurate determination of the inner point of the involute profile of undercut spur and helical gear teeth is presented. This point may have influence on the effective path of contact and consequently on the contact ratio, the length of the path of contact and the stress levels, which should be taken into account for calculation and standardization purposes. Since the equation is valid for any tool proportions, it is very efficient for computer applications.
PedreroJ. I.García-MasiáC.FuentesA.On the location of the tooth critical section for the determination of the AGMA J-factor. AGMA paper 97FTM6, 1997.
2.
FuentesA.Modelo de cálculo a flexión de engranajes cilíndricos de perfil de evolvente. PhD thesis, UNED, Madrid, 1996.
3.
AGMA Information Sheet 908-B89 Geometry Factors for Determining the Pitting Resistance and Bending Strength of Spur, Helical and Herringbone Gear Teeth, 1989 (American Gear Manufacturers Association, Alexandria, Virginia).
4.
MitchinerR. G.MabieH. H.The determination of the Lewis form factor and the AGMA geometry factor J for external spur gear teeth. J. Mech. Des., January 1982, 104(1), 148–158.
5.
PedreroJ. I.RuedaA.FuentesA.Determination of the ISO tooth form factor for involute spur and helical gears. Mech. Mach. Theory, January 1999, 34(1), 89–103.
6.
ISO 6336 Calculation of Load Capacity of Spur and Helical Gears, 1996 (International Standardization Organization, Geneva, Switzerland).
7.
AGMA 2001-C95 Fundamental Rating Factors and Calculation Methods for Involute Spur and Helical Gear Teeth 1995 American Gear Manufacturers Association Alexandria, Virginia.
