Contact and elastohydrodynamic analysis of worm gears Part 2: Results

Abstract

The paper presents the results of modelling the contact and elastohydrodynamic lubrication (EHL) effects between the teeth of worm gears. A number of different practical worm gear designs have been studied covering a wide range of sizes and potential applications, from small instrument drives to high power units. All the designs are of the popular ZI type, in which the worm is an involute helicoid, with deliberate mismatch of tooth conformity in order to avoid damaging edge contact. The results cover loaded tooth contact analysis (‘loaded TCA’) under dry conditions, predicted film-generating behaviour with lubrication, surface and oil film temperatures, and calculated values of friction and transmission efficiency. It is demonstrated that regions of poor film formation may be predicted in a qualitative way on the basis of loaded TCA together with consideration of the kinematics of entrainment at the contacts.

Keywords

worm gears elastohydrodynamic thermal non-Newtonian

Get full access to this article

View all access options for this article.

References

Sharif

K. J.

Kong

Evans

H. P.

Snidle

R. W.

Contact and elastohydrodynamic analysis of worm gears. Part 1: theoretical formulation. Proc. Instn Mech. Engrs, Part C, Journal of Mechanical Engineering Science, 2001, 215(C7), 817–830.

DIN 3975, Terms and definitions for cylindrical worm gears with shaft angle of 90°, Berlin, Germany, 1976.

The kinematic analysis and metrology of cylindrical worm gearing. PhD thesis, University of Newcastle upon Tyne, 1997.

Larsson

P. O.

Eriksson

Sjöberg

Höglund

Lubricant properties for input to hydrodynamic and elastohydrodynamic lubrication analyses. Proc. Instn Mech. Engrs, Part J, Journal of Engineering Tribology, 2000, 214(J1), 17–28.

Yang

Gentle

C. R.

Mesh stiffness and tooth stress calculation for worm gears using finite element method. In Proceedings of International Conference on Gearing, Transmissions, and Mechanical Systems, Nottingham Trent University, July 2000, pp. 129–139 (Professional Engineering Publishing, London).

Chittenden

R. J.

Dowson

Dunn

J. F.

Taylor

C. M.

A theoretical analysis of the isothermal elastohydrodynamic lubrication of concentrated contacts. Proc. R. Soc. (Lond.) A, 1985, 397, 271–294.

Vos

Design measures increase the capacity of worm gear units. Maschinenmarkt, February 1996, (8), 56–59.

Britton

R. D.

Elcoate

C. D.

Alanou

M. P.

Evans

H. P.

Snidle

R. W.

Effect of surface finish on gear tooth friction. Trans. ASME, J. Tribology, 2000, 122, 354–360.

Krantz

T. L.

Alanou

M. P.

Evans

H. P.

Snidle

R. W.

Surface fatigue lives of case-carburized gears with an improved surface finish. Trans. ASME, J. Tribology, 123 (in press).