Indentation of a sandwich beam is analysed as linear elastic bending of the top skin on a rigid-perfectly plastic foundation (the core). The theoretical predictions of fracture load from this simple theory are shown to be in good agreement with experimental results from indentation tests on strips of sandwich panel, with glass-fibre-reinforced plastic skins and foam core, supported on a rigid base.
ReddyT. Y.SodenP. D.ReidS. R.WenH. M.‘Design and performance of sandwich panel elements for impact energy absorption and resistance to penetration’, Part 2 of Final Report on Project CP202 (MARINETECH Collaborative Programme of Research on Cost Effective Use of Composites Offshore, Phase II), 1993 (MARINETECH Research, Manchester).
2.
FentonJ. B.‘Sandwich panels for vehicle bodies’, Automot. Des. Engng, November 1962, 47–49.
3.
SayieghA. A. M.Sandwich beams and panels under bending and buckling loads, PhD thesis, University of London, 1966.
4.
ZingoneG.‘Limit analysis of a beam in bending immersed in an elastoplastic medium’, Meccanica, March 1968, 48–56.
5.
ShuaeibF. M.Bending and indentation failure of composite sandwich beams, MSc Thesis, UMIST, 1991.
6.
7.
SodenP. D.AkfertA.ReddyT. Y.‘Indentation of sandwich beams’, Proceedings of Third International Conference onSandwich Construction, Southampton, September 1995.
8.
GreenR. J.‘Pentration of a beam on a plastic foundation’, Proc. Am. Soc. Civ. Engng, December 1971, 97 (EM6), 1769–1772.
9.
WilseaM.JohnsonK. L.AshbyM. F.‘Indentation of foamed plastics’, Int. J. Mech. Sci., 1975, 17.
