The use of a bree simulation to investigate strain accumulation in 316 stainless steel at temperatures between room temperature and 500°c

Abstract

This paper details tests undertaken to determine the 1 per cent strain accumulation boundary in stainless steel type 316 strip subjected to constant axial tension and a cyclic change of curvature. Boundaries are obtained for temperatures between 300 and 500°C. These are compared with two design rules, both of which are shown to be conservative. Additionally, the temperature at which the transition from the characteristic room temperature behaviour of continued ratchetting to the ‘shakedown’ observed at elevated temperatures is investigated. Results obtained indicate that this transition temperature is influenced by the magnitude of the applied stresses.

Get full access to this article

View all access options for this article.

References

Clement

Lebey

Roche

R. L.

‘A design rule for thermal ratchetting’, 5th Int. Conf. on Pressure Vessel Technology, 1984, San Francisco.

AMERICAN SOCIETY OF MECHANICAL ENGINEERS Boiler and Pressure Vessel Code, Sec. III, Div. 1, ANSI/ASME BPVC III/1/NC, 1982.

Moreton

D. N.

H. W.

‘The extention and verification of the Bree diagram’, 6th Int. SMiRT, 1981 Paris, L10/2.

Bree

‘Elastic-plastic behaviour of thin tubes subjected to internal pressure and intermittent high heat fluxes with application to fast nuclear reactor fuel elements’, J. Strain Analysis, 1967, 2, 226–238.

Corsi

Giannuzzi

G. M.

Giamberardino

P. D.

Taddia

‘Design of the structural behaviour of a nozzle charged by primary loads and cyclic thermal shocks’, 8th Int. SMiRT, 1985, Brussels, Belgium, L7/5, pp. L353–358.

Megahed

M. M.

Hayhurst

D. R.

Leckie

F. A.

‘Cyclic plastic behaviour of structural components’, Int. J. mech. Engng. Education, 1982, 10, 235–257.

H. W.

Brookfield

D. J.

Moreton

D. N.

‘A technique for conducting shakedown tests at elevated temperatures’, Strain, 1984, 20, 7–14.

Brookfield

D. J.

Morton

D. N.

‘The behaviour of stainless steel type 316 under Bree type loading at elevated temperatures’, 8th Int. SMiRT, 1985, Brussels, Belgium, L7/6, pp. L359–364.

Brookfield

D. J.

Moreton

D. N.

‘The ratchetting behaviour of stainless steel type 316 at ambient and elevated temperatures’, 9th Int. SMiRT, 1987.