The effectiveness of the length by which a radial branch pipe extends within a spherical pressure vessel is discussed with reference to the plastic limit pressure of the vessel and the design rules of BS 5500. Lower bound limit pressures are calculated using a non-linear programming method, the stress resultants being expressed in polynomial form. The material was assumed to be rigid-plastic and to obey the von Mises yield criterion.
DinnoK. S.GillS. S.‘Limit pressure for a protruding cylindrical nozzle in a spherical pressure vessel’, J. mech. Engng Sci., 1965, 7, 259–270.
3.
LimC. S.Plastic limit pressures for pressure vessels with defects at openings, PhD thesis, University of Manchester, 1986.
4.
RobinsonM.‘The effect of transverse shear stresses on the yield surface for thin shells’, Int. J. Solids Structures, 1973, 9, 819–828.
5.
RobinsonM.‘A lower bound to the limit pressure of a flush oblique cylindrical branch on a spherical pressure vessel’, Int. J. mech. Sci., 1972, 14, 579–601.
6.
CarrollC. W.‘The created response surface technique for optimising non-linear restrained systems’, Ops Res., 1961, 9, 169–184.
