A finite-element method has been used to calculate crack extension forces for experimental fracture specimens which failed after general yield. The results are compared with the values of the J-integral for the same specimens, and a significant discrepancy is noted. The crack extension forces at failure for a centre-notch and bend specimen of the same material were found to be almost identical, but did not agree with the plane strain GIC value reported for thick-section specimens.
Get full access to this article
View all access options for this article.
References
1.
RiceJ. R.‘A path independent integral and the approximate analysis of strain concentration by notches and cracks’, J. appl. Mech. Trans. Am. Soc. mech. Engrs196835, 379–386.
2.
BegleyJ. A.LandesJ. D.‘TheJ integral as a fracture criterion’, A.S.T.M. STP 514 (1972), 1–20.
3.
LandesJ. D.BegleyJ. A.‘The effect of specimen geometry on JIC’ A.S.T.M. STP 514 (1972), 24–39.
4.
LightM. F.LuxmooreA. R.‘A numerical investigation of post-yield fracture’, J. Strain Analysis197712, 293–304.
5.
BurdekinF. M.StoneD. E. W.‘The crack opening displacement approach to fracture mechanics in yielding materials’, J. Strain Analysis19661, 145–153.
6.
KeJ. S.LiuH. W.‘The measurement of fracture toughness of ductile materials’, Engng Fract. Mech.19735, 187–202.
7.
BoyleE. F.‘The calculation of elastic and plastic crack extension forces’, Ph.D. thesis, 1972. Queen's University, Belfast.
8.
LightM. F.LuxmooreA. R.EvansW. T.‘Prediction of slow crack growth by a finite element method’, Int. J. Fract.197511, 1045–1046.
