An investigation has been made into the suitability of the finite-element method for studying the stresses in composite materials and the case of a single broken fibre in a matrix has been examined. It has been found that high stress concentrations occur in the region of the fibre break which increase with decreasing end gap and would cause matrix yielding or fracture at comparatively low overall stresses. When the end gap is not void but filled with matrix much lower stress concentrations occur which, below a certain value of end gap, actually decrease as the gap is made smaller.
Get full access to this article
View all access options for this article.
References
1.
KellyA.DaviesG. J.‘The principles of the fibre reinforcement of metals’, Metall. Rev.196510 (No. 37), 1.
2.
CratchleyD.‘Experimental aspects of fibre-reinforced metals’, Metall. Rev.196510 (No. 37), 79.
3.
CoxH. L.‘The elasticity and strength of paper and other fibrous materials’, Br. J. appl. Phys.19523, 72.
4.
DowN. F.‘Study of stresses near a discontinuity in a filament-reinforced composite material’, G.E.C. Rept. R63SD61, 1963.
5.
TysonW. R.DaviesG. J.‘A photoelastic study of the shear stresses associated with the transfer of stress during fibre reinforcement’, Br. J. appl. Phys.196516, 199.
6.
SchusterD. M.ScalaE.‘The mechanical interaction of sapphire whiskers with a birefringent matrix’, Trans. Am. Inst. Min. Engrs1964230, 1635.
MacLaughlinT. F.SalkindM. J.‘Effect of fibre geometry on stress in fibre-reinforced composite materials’, Watervliet Arsenal Rept. WVT-6521 (AD-616520), 1965.
10.
CloughR. W.‘The finite element method in plane stress analysis’, Proc. 2nd Conf. Electron. Comput.1960, 231 (American Society of Civil Engineers, New York).
11.
WilsonE. L.‘Finite element analysis of two-dimensional structures’, Struct. Engng Lab. Rept. 63–2, 1963 (University of California, Berkeley).
12.
DixonJ. R.VisserW.‘An investigation on the elasticplastic strain distribution around cracks in various sheet materials’, Proc Int. Symp. Photoelasticity1961, 345.
13.
BakerA. A.CratchleyD.‘Metallographic observations on behaviour of silica reinforced aluminium under fatigue loading’, Appl. Mat. Res.19643, 215.
14.
HamR. K.PlaceT. A.‘The failure of copper-tungsten fibre composites in repeated tension’, J. Mech. Phys. Solids196614, 271.
15.
KellyA.TysonW. R.‘Tensile properties of fibre reinforced metals-II. Creep of silver tungsten’, J. Mech. Phys. Solids196614, 177.
