Following the 25 April 2015 Mw 7.8 Gorkha, Nepal, earthquake and subsequent aftershocks, field surveys were conducted on medium-to-high rise reinforced concrete (RC) frame buildings with masonry infill located in the Kathmandu Valley. Rapid visual assessment, ambient vibration testing, and ground-based lidar (GBL) showed that these buildings suffered damage ranging from light to severe, where damage occurred in both structural and nonstructural elements, but was most prevalent in nonstructural masonry infills. Finite-element structural analyses of selected buildings corroborate field observations of only modest structural damage. The lack of severe structural damage in this relatively limited class of engineered medium-to-high rise RC infill frame buildings illustrates the impact of modern seismic design standards and stands in stark contrast to the severe damage and collapse observed in low-rise nonengineered RC infill frame buildings. Nonetheless, the nonstructural damage hindered many of these buildings from being occupied for many months following the earthquake and subsequent aftershocks.
Get full access to this article
View all access options for this article.
References
1.
ACI (American Concrete Institute), 2014. Building Code Requirements for Structural Concrete and Commentary (ACI 318-14), Farmington Hills, MI.
2.
ASCE (American Society of Civil Engineers), (2010). Minimum Design Loads for Buildings and Other Structures. ASCE 7-10, Reston, VA (includes Supplement 1).
3.
ASCE (American Society of Civil Engineers), 2013. Seismic Evaluation and Upgrade of Existing Buildings. ASCE 41-13, Reston, VA.
4.
AsimakiD., MohammadiK., MasonH. B., AdamsR. K., RajaureS., and KhadkD., 2017. Observations and simulations of basin effects in the Kathmandu Valley during the 2015 Gorkha earthquake sequence. Earthquake Spectra (in press). doi:10.1193/013117EQS022M.
5.
BernalD., DöhlerM., KojidiS. M., KwanK., and LiuY., 2015. First mode damping ratios for buildings. Earthquake Spectra31, 367–381.
6.
BevingtonJ., 2015. April 25, 2015 Nepal earthquake and aftershocks: building codes. EERI Briefing Series of Videos, Oakland, CA.
7.
BoseS., NozariA., StavridisA., and MoaveniB., 2017. Nonlinear modeling of the seismic performance of a building at Sankhu, Nepal, during the 2015 Nepal earthquake. Proceedings of the 16th World Conference on Earthquake Engineering, 9–13 January 2017, Santiago Chile.
8.
BrandoG., RaponeD., SpaconeE., O'BanionM. S., OlsenM. J., BarbosaA. R., FaggellaM., GigliottiR., LiberatoreD., RussoS., SorrentinoL., BoseS., and StravidisA., 2017. Damage reconnaissance of unreinforced masonry bearing wall buildings after the 2015 Gorkha, Nepal, earthquake, Earthquake Spectra33, S243–S273.
9.
BrandowG., CarpenterL., CochranM. B., HartG. C., HuangS. C., LewM., MartinM. J., NaeimF., PinkhamM. C., SabolT. A., and SchindlerM. B., 2014. An Alternative Procedure for Seismic Analysis and Design of Tall Buildings Located in the Los Angeles Region, Los Angeles Tall Buildings Structural Design Council, Los Angeles, CA.
10.
BrinckerR., and KirkegaardP. H., 2010. Editorial., Mechanical Systems and Signal Processing, Special Issue on Operational Modal Analysis24, 1209–1212.
11.
Bureau of Indian Standards (BIS), 2002. Criteria for Earthquake Resistant Design of Structures, Part 1: General Provisions and Buildings> (fifth revision). IS 1893, Noida, Uttar Pradesh, India.
12.
Bureau of Indian Standards (BIS), 1993. Ductile Detailing of Reinforced Concrete Structures Subjected to Seismic Forces—Code of Practice. IS 3920, Noida, Uttar Pradesh, India.
13.
Digital Signal Processing Committee of the IEEE and Acoustics, Speech, and Signal Processing Society, eds., 1979. Programs for Digital Signal Processing. IEEE Press, Hoboken, NJ.
14.
FahnestockL. A., and HashashY. M. A., 2016. Structural and Geotechnical Observations after the April 25, 2015 M7.8 Gorkha, Nepal Earthquake and Its Aftershocks. Newmark Structural Engineering Report Series, No. 46, University of Illinois at Urbana-Champaign, Urbana, IL. Available from: https://www.ideals.illinois.edu/handle/2142/95138.
15.
GautamD., and ChaulagainH., 2016. Structural performance and associated lessons to be learned from world earthquake in Nepal after 25 April 2015 (MW 7.8) Gorkha earthquake. Engineering Failure Analysis68, 222–243.
16.
NBC (National Building Code), 1994a. Requirements for State-of-the-Art Design: An Introduction. NBC 000, Government of Nepal, Kathmandu.
17.
NBC (National Building Code), 1994b. Mandatory Rules of Thumb: Reinforced Concrete Buildings with Masonry Infill. NBC 201, Government of Nepal, Babar Mahal, Kathmandu.
18.
NBC (National Building Code), 1994c. Mandatory Rules of Thumb: Reinforced Concrete Buildings without Masonry Infill. NBC 205, Government of Nepal, Kathmandu.
19.
HarrisA., XiangY., NaeimF., and ZareianF., 2015. Identification and validation of natural periods and modal damping ratios for steel and reinforced concrete buildings in California. Proceedings of the in SMIP15 Seminar on Utilization of Strong-Motion Data, California Department of Conservation, Sacramento, CA, 21–134.
20.
JamesG. H., CarneT. G., LaufferJ. P., and NordA. R., 1992. Modal testing using natural excitation. Proceedings of the International Modal Analysis Conference, SEM Society for Experimental Mechanics, Bethel, CT, 1209–1216.
21.
JuangJ. N., and PappaR. S., 1985. An eigensystem realization algorithm for modal parameter identification and model reduction. Journal of Guidance, Control, and Dynamics8, 620–627. doi:10.2514/3.20031.
22.
MoaveniB., BarbosaA. R., ConteJ. P., and HemezF. M., 2014. Uncertainty analysis of system identification results obtained for a seven story building slice tested on the UCSD-NEES shake table. Structural Control and Health Monitoring21, 466–483.
23.
MoehleJ. P.2007. The Tall Buildings Initiative for alternative seismic design. Structural Design of Tall and Special Buildings16, 559–567.
24.
NPC (National Planning Commission), 2015. Nepal Earthquake 2015: Post Disaster Needs Assessment, Government of Nepal, Kathmandu.
25.
OlsenM. J., CheungK. F., YamazakiY., ButcherS., GarlockM., YimS., PiaskowyS., RobertsonI., BurgosL., and YoungY. L., 2012. Damage assessment of the 2010 Chile earthquake and tsunami using terrestrial laser scanning. Earthquake Spectra28, S179–S197.
26.
OlsenM. J., KuesterF., ChangB., and HutchinsonT., 2010. Terrestrial laser scanning based structural damage assessment. Journal of Computing in Civil Engineering24, 264–272.
27.
PEER/ATC (Pacific Earthquake Engineering Research Center/Applied Technology Council), 2010. Interim Guidelines on Modeling and Acceptance Criteria for Seismic Design and Analysis of Tall Buildings, PEER/ATC 72-1, Redwood City, CA.
28.
PintelonR., GuillaumeP., and SchoukensJ., 2007. Uncertainty calculation in operational modal analysis. Mechanical Systems and Signal Processing21, 2359–2373.
29.
PujolS., and FickD.2010, The test of a full-scale three-story RC structure with masonry infill walls. Engineering Structures32, 3112–3121.
30.
RanaB. S. J. B., 1935. Nepal Ko Maha Bhukamapa [Great earthquake of Nepal], 2nd ed., Kathmandu (self-published).
31.
ReyndersE., PintelonR., and De RoeckG., 2008. Uncertainty bounds on modal parameters obtained from stochastic subspace identification. Mechanical Systems and Signal Processing22, 948–969.
32.
RossettoT., and ElnashaiA., 2003. Derivation of vulnerability functions for European-type RC structures based on observational data. Engineering Structures25, 1241–1263. doi:10.1016/S0141-0296(03)00060-9.
33.
SAP2000, Version 16., 2013. Software. Computers and Structures, Berkeley, CA.
34.
SatakeN., SudaK. I., ArakawaT., SasakiA., and TamuraY., 2003. Damping evaluation using full-scale data of buildings in Japan. Journal of Structural Engineering129, 470–477. doi:10.1061/(ASCE)0733-9445(2003)129:4(470).
35.
SpenceS., and KareemA., 2014. Tall buildings and damping: a concept-based data-driven model, Journal of Structural Engineering140, 04014005. doi:10.1061/(ASCE)ST.1943-541X.0000890.
36.
TakaiN., ShigefujiM., RajaureS., BijukchhenS., IchiyanagiM., DhitalM. R., and SasataniT., 2016. Strong ground motion in the Kathmandu Valley during the 2015 Gorkha, Nepal, Earthquake. Earth, Planets and Space68(10), 1–8 doi:10.1186/s40623-016-0383-7
37.
Tall Buildings Initiative (TBI), 2010. Guidelines for Performance-Based Seismic Design of Tall Buildings, Pacific Earthquake Engineering Research Center, Berkeley, CA
38.
YuH., MohammedM. A., MohammadiM. E., MoaveniB., BarbosaA. R., StavridisA., and WoodR. L., 2017. Structural identification of an 18-story RC building in Nepal using post-earthquake ambient vibration data. Frontiers in the Built Environment. doi:10.3389/fbuil.2017.00011.
