Sage Journals: Discover world-class research

Abstract

A procedure is set out for calculating the buoyant flow induced in a duct with heat input at the wall, as in the cooling ducts used behind photovoltaic arrays. In these, buoyancy is opposed by various pressure losses, due to obstructions at the inlet and outlet, fluid friction at the walls and structural support members passing transversely through the duct. New methods are developed for calculating these losses, and each is validated separately by tests in a purpose-built isothermal rig. Measurements are also reported for some further losses, not yet amenable to calculation, due to nets and hoods at the duct ends, as might be used to exclude rain and wildlife. Finally, the whole procedure is validated by measurement of a duct with one heated wall.

Practical application: Verified by measurements at every stage of its development, the method reported gives greater confidence in the routine calculation of the flow induced in ductwork where there is heat gain, as in systems for PV cooling and natural ventilation. The new treatments given for the hydrodynamic losses at basic components apply wherever these are used in the field of HEVAC.

Get full access to this article

View all access options for this article.

References

Brinkworth BJ . Estimation of flow and heat transfer for the design of PV cooling ducts. Solar Energy 2000; 69: 413–420.

Brinkworth BJ , Marshall RH , Ibarahim Z . A validated model of naturally-ventilated PV cladding. Solar Energy 2000; 69: 67–81.

Sandberg M , Moshfegh B . Buoyancy-induced air flow in photovoltaic facades: effect of geometry of the air gap and location of solar cell modules. Building and Environment 2002; 37: 211–218.

Kakac S , Shah RK , Aung W editors, Handbook of single-phase convective heat transfer. New York: Wiley, 1987.

ASHRAE Handbook: fundamentals. Atlanta: ASHRAE, 1985.

Lundström H , Sandberg M . Some methods for measuring natural convection flows in ventilation applications. Proceedings ROOM-VENT 2002; 8th International Conference on Air Distribution in Rooms. Copenhagen, Denmark, 2002.

Sandberg M , Moshfegh M . Investigation of fluid flow from heat transfer in a vertical channel heated from one side by PV elements. Part II. Proceedings of the fourth Renewable Energy Conference. Denver, USA, 1996.

Lamb H . Hydrodynamics. Cambridge: Cambridge University Press, 1962.

Rouse H . Elementary mechanics of fluids. New York: Wiley, 1946.

10.

Groth J , Johansson AV . Turbulence reduction by screens. J. Fluid Mechs. 1988; 197: 139–155.

11.

Baines WD , Petersen EG . An investigation of flow through screens. Trans. ASME 1951; 73: 467–480.

12.

Han JC . Heat transfer and friction characteristics in rectangular channels with rib turbulators. ASME J. Heat Trans. 1988; 110: 321–328.

13.

Chandra PR , Alexander CR , Han JC . Heat transfer and friction behaviours in rectangular channels with varying number of ribbed walls. Int. J. Heat Mass Trans. 2003; 46: 481–495.

14.

Liou T-M , Hwang J-J . Turbulent heat transfer augmentation and friction in periodic fully developed channel flows. ASME J. Heat Trans. 1992, 114: 56–64.

15.

Prasad BN , Saini JS . Effect of artificial roughness on heat ransfer and friction factor in solar air heaters. Solar Energy 1988; 41: 555–560.

16.

Cui J , Patel VC , Lin C-L . Large-eddy simulation of turbulent flow in a channel with rib roughness. Heat and Fluid Flow 2003; 24: 372–388.

17.

Hwang J-J . Heat transfer—friction characteristic comparison in rectangular ducts with slit and solid ribs mounted on one wall. ASME J. Heat Trans. 1998; 120: 709–716.

A validated procedure for determining the buoyancy-induced flow in ducts

Abstract

Get full access to this article

References