This paper presents a study of dielectric properties, namely the relative permittivity and loss factor dependence on the frequency of a weak electric field. Perovskite CaTiO3 was studied in the form of coatings and self-supporting plates made by plasma spraying. A conventional gas stabilised plasma gun (GSP) as well as a water stabilised plasma gun (WSP) were employed. It was observed that plasma sprayed titanates exhibit a strong relaxation of permittivity and loss factor decrease with a frequency rise. These properties are influenced by spray technique and spraying parameters, but the relaxation character in general is preserved in all cases. The volume resistivity of the samples was studied as well. Several aspects of the structural features of plasma deposits, especially the phase composition, porosity character, and their influence on dielectric properties are discussed.
SampathS: ‘Thermal spray applications in electronics and sensors: past, present, and future’, J. Thermal Spray Technol., 2010, 19, (5), 921–949.
2.
TomaF.-L, ScheitzS, PuschmannR, BergerL.-M: ‘Development of ceramic heating elements produced by thermal spray technology’, Proc. Intl. Thermal Spray Conf., Düsseldorf, Germany, 2011, DVS, 912–917.
3.
CtiborP, LechnerováR, BenešV: ‘Quantitative analysis of pores of two types in a plasma-sprayed coating’, Mater. Character., 2006, 56, 297–304.
4.
FriedrichC, GadowR, KillingerA: ‘Thermally sprayed multilayer coatings as electrodes and dielectrics in high efficiency ozonizer tubes’, Proc. United Thermal Spray Conf. ’99, Düsseldorf, Germany, 1999, 676–682.
5.
JansingT, FleckR, DeckerJ, VerpoortC: ‘Separation and insulating layers of atmospheric plasma-sprayed ceramics for high temperature fuel cells - development and implementation’, Proc. United Thermal Spray Conf. ’99, Düsseldorf, Germany, 1999, 69–75
6.
DentAH, PatelA, GutleberJ, TormeyE, SampathS, HermanH: ‘High velocity oxy-fuel and plasma deposition of BaTiO3 and (Ba,Sr)TiO3’, Mater. Sci. Eng. B, 2001, 87B, 23–30.
7.
‘Gmelins handbook of inorganic chemistry’, Vol. 41–42; 1951, Leipzig.
8.
LandoltH, BoernsteinR: ‘Values and functions in physics, chemistry, astronomy, geophysics and technology’, Vol. IV, Part 3; 1957, Berlin, Springer Verlag.
9.
ParidaS, RoutSK, GuptaN, GuptaVR: ‘Solubility limits and microwave dielectric properties of Ca(ZrxTi1-x)O3 solid solution’, J. Alloys Compd, 2013, 546, 216–223.
10.
ChenX, BaiS, ZhangW: ‘Low temperature sintering and microwave dielectric properties of Bi4B2O9-added 0·25CaTiO3–0·75(Li1/2Nd1/2)TiO3 ceramics’, J. Alloys Compd., 2012, 541, 132–136.
11.
LowndesR, AzoughF, CernikR, FreerR: ‘Structures and microwave dielectric properties of Ca(1−x)Nd2x/3TiO3 ceramics’, J. Eur. Ceram. Soc., 2012, 32, 3791–3799.
ChenX, LiY, KongF, LiL, SunQ, WangF: ‘Red, green, blue and bright white upconversion luminescence of CaTiO3: Er3+/Tm3+/Yb3+ nanocrystals’, J. Alloys Compd, 2012, 541, 505–509.
14.
HuongDTM, NamNH, VuLV, LongNN: ‘Preparation and optical characterization of Eu3+-doped CaTiO3 perovskite powders’, J. Alloys Compd., 2012, 537, 54–59.
15.
BhamuKC, DashoraA, AroraG, AhujaBL: ‘Nature of bonding in CaTiO3 and SrTiO3: a compton scattering study’, Rad. Phys. Chem., 2012, 81, 728–734.
16.
‘Structure and properties of ceramics’, (ed. KollerA, ed), 496; 1994, Elsevier.
17.
CtiborP, SedlacekJ: ‘Dielectric properties of plasma sprayed titanates’, J. Europ. Ceram. Soc., 2001, 21, 1685–1688.
18.
CtiborP, SedlacekJ, NeufussK, ChraskaP: ‘Dielectric relaxation in calcium titanate-containing ceramics prepared by plasma’, Ceram. Int., 2003, 29, 955–960.
19.
CtiborP, SedlacekJ: in ‘Advances in ceramics - characterization, raw materials, processing, properties, degradation and healing’, (, SikalidisC), 19–38; 2011, Wien, InTech.
20.
CtiborP, PalaZ, BoldyryevaH, SedlacekJ, KmetikV: ‘Microstructure and properties of plasma sprayed lead zirconate titanate (PZT) ceramics’, Coatings, 2012, 2, 64–75.
21.
SindhuM, AhlawatN, SanghiS, AgarwalA, DahiyaR, AhlawatN: ‘Rietveld refinement and impedance spectroscopy of calcium titanate’, Current Appl. Phys., 2012, 12, 1429–1435.
Czech Standard CSN IEC 250, Czech Institute for Standardization, Prague, 1997.
24.
MoreyO, GoeuriotP, JuveD, TreheuxD: ‘Dielectric investigations on ‘MgAlON’ compounds: role of nitrogen content’, J. Eur. Ceram. Soc., 2003, 23, 345–355.
25.
‘US Standard ASTM D 257–66: standard test methods for DC resistance or conductance of insulating materials’, ASTM International, West Conshohocken, PA, 19428–2959.
HillNE: ‘Dielectric properties and molecular behaviour’; 1969, London, Van Nostrand-Reinhold.
28.
CtiborP, StenglV, PisI, ZahoranovaT, NehasilV: ‘Plasma sprayed TiO2: the influence of power of an electric supply on relations among stoichiometry, surface state and photocatalytic decomposition of acetone’, Ceram. Int., 2012, 38, 3453–3458.
29.
Taibi BenziadaL, MezrouaA, Von Der MuhllR: ‘CaTiO3 related materials for resonators’, Ceramics Silikaty, 2004, 48, 180–184.
30.
CannilloV, PierliF, SampathS, SiligardiC: ‘Thermal and physical characterisation of apatite/wollastonite bioactive glass–ceramics’, J. Eur. Ceram. Soc., 2009, 29, 611–619.
