High temperature behaviour of glass-vinyl ester stack liner

Abstract

High temperature behaviour of glass-vinyl ester stack liner at the operation temperature (20–121°C) was experimentally investigated by measurements on the small specimens and full scale specimens in this paper. Based on the stacking sequences of a typical glass-vinyl ester stack liner, three groups of small specimens were produced to evaluate the degradation of their tensile and compressive strength, the tensile modulus, and the flexural strength and modulus with increasing temperature, and one group of full scale specimens was prepared to measure their properties at room temperature. Furthermore, the ultimate axial tensile stress of a suspended glass-vinyl ester stack liner at various temperatures was derived according to the experimental results from the small specimens and full scale specimens. The high temperature behaviour of composites stack liner from the tests can be used as reference for determining the extreme operation temperature in coal-fired power plants.

Keywords

Stack liner High temperature behaviour Mechanical testing Vinyl ester

Get full access to this article

View all access options for this article.

References

and Kodur

: Compos. B Eng., 2014, 58, 510–517. doi: 10.1016/j.compositesb.2013.10.055

Wang

Y. C.

and Kodur

: Cem. Concr. Compos., 2005, 27, (9-10), 864–874. doi: 10.1016/j.cemconcomp.2005.03.012

Wang

Y. C.

, Wong

P. M. H.

and Kodur

: Compos. Struct., 2007, 80, (1), 131–140. doi: 10.1016/j.compstruct.2006.04.069

Bai

and Keller

: Compos. Struct., 2011, 93, (2), 843–849. doi: 10.1016/j.compstruct.2010.07.010

Carvelli

, Pisani

M. A.

and Poggi

: Compos. B Eng., 2013, 54, 125–132. doi: 10.1016/j.compositesb.2013.05.013

Saafi

: Compos. Struct., 2002, 58, (1), 11–20. doi: 10.1016/S0263-8223(02)00045-4

El-Karmoty

H. Z.

: HBRC J., 2012, 8, (2), 115–122. doi: 10.1016/j.hbrcj.2012.09.007

Masmoudi

, Masmoudi

, Ouezdou

M. B.

and Daoud

: Constr. Build. Mater., 2011, 25, (2), 486–493. doi: 10.1016/j.conbuildmat.2009.12.040

Al-Safy

, Al-Mahaidi

and Simon

G. P.

: Compos. B Eng., 2013, 48, 140–157. doi: 10.1016/j.compositesb.2012.10.035

10.

Pagani

, Bocciarelli

, Carvelli

and Pisani

M. A.

: Eng. Struct., 2014, 81, 318–326. doi: 10.1016/j.engstruct.2014.10.012

11.

Khaliq

and Kodur

: Cem. Concr. Res., 2011, 41, (11), 1112–1122. doi: 10.1016/j.cemconres.2011.06.012

12.

Trapko

: Compos. B Eng., 2013, 54, 138–145. doi: 10.1016/j.compositesb.2013.05.016

13.

Al-Safy

, Al-Mahaidi

and Simon

G. P.

: Compos. Struct., 2013, 95, 295–306. doi: 10.1016/j.compstruct.2012.06.027

14.

Al-Salloum

Y. A.

, Elsanadedy

H. M.

and Abadel

A. A.

: Constr. Build. Mater., 2011, 25, (2), 838–850. doi: 10.1016/j.conbuildmat.2010.06.103

15.

Al-Shawaf

and Int

: Adhes Adhes., 2011, 31, (6), 416–428. doi: 10.1016/j.ijadhadh.2011.02.005

16.

Di Ludovico

, Piscitelli

, Prota

, Lavorgna

, Mensitieri

and Manfredi

: Constr. Build. Mater., 2012, 31, 273–283. doi: 10.1016/j.conbuildmat.2011.12.105

17.

Gamage

J. C. P. H.

, Al-Mahaidi

and Wong

M. B.

: Comp. Struct., 2006, 75, (1–4), 199–205. doi: 10.1016/j.compstruct.2006.04.068

18.

and Kodur

V. K. R.

: Compos. Struct., 2014, 110, 88–97. doi: 10.1016/j.compstruct.2013.11.021

19.

ASTM D5364,; 2008;. Standard guide for design, fabrication, and erection of fiberglass reinforced (FRP) plastic chimney liners with coal-fired units..

20.

ASTM D695, Standard test method for compressive properties of rigid plastics; 2010.

21.

ASTMD3039/D 3039M, Standard test method for tensile properties of polymer matrix composite materials; 2008.

22.

ASTM D790, Standard test method for flexural properties of unreinforced and reinforced plastics and electrical insulating materials; 2010.

23.

‘Technical datasheet’. Available at: www.ashland.com /products/derakane-epoxy-vinyl-ester-resin.