Abstract
Bending-mode polyimide-based (PI) electromagnetic microactuators with different geometries were fabricated and tested. Fabrication of the electromagnetic microactuator consists of electroplated 10 μm thick Ni/Fe (80: 20) permalloy on a PI diaphragm, high aspect ratio electroplating of a copper planar micro-coil, bulk micromachining, low-temperature bonding, and 248 nm excimer laser selective ablation. They were fabricated by a novel concept avoiding the etching selectivity and residual stress problems which occur during wafer etching. The magnetic field generated by the planar micro-coil was used to provide an external magnetic field (H ext) to interact with Ni/Fe on the PI diaphragm, by which a repulsive force can be induced to provide a large deflection angle. The deflection angle of the microactuator with different H ext values was measured. Preliminary results show that 82° can be obtained. In addition, to provide a high strength and low temperature bonding process for the microactuator system, a polymer-based photoresist with patternable characteristics was used as the adhesive bonding material. The bonding results for different photoresists are compared and discussed.
Get full access to this article
View all access options for this article.