Effects of electric pulses on the annealing hardening of submicrometre grained (0.1 μm < D < 1 μm) Cu processed by heavy cold rolling were investigated. Annealing induced hardening occurred after moderate annealing, which can be attributed to the dislocation source hardening rather than aging hardening, based on the fact that the ultrapure Cu showed higher hardening effect than commercial pure Cu. Electric pulses induced enhancement in the hardening effect for ultrapure Cu, but not for commercial pure Cu. The TEM investigations show that dislocation recovery was enhanced by electric pulses for ultrapure Cu, but not for commercial pure Cu due to the pinning effects of impurity, and negligible growth in both cases due to the short treatment time.
EstrinY. and VinogradovA.: ‘Extreme grain refinement by severe plastic deformation: a wealth of challenging science’, Acta Mater., 2013, 61, (3), 782–817.
2.
KamikawaN., HuangX., TsujiN. and HansenN.: ‘Strengthening mechanisms in nanostructured high-purity aluminium deformed to high strain and annealed’, Acta Mater., 2009, 57, (14), 4198–4208.
3.
WeertmanJ. R.: ‘Hall-Petch strengthening in nanocrystalline metals’, Mater. Sci. Eng. A, 1993, A166, 161–167.
4.
JiaD., WangY. M., RameshK. T., MaE., ZhuY. T. and ValievR. Z.: ‘Deformation behavior and plastic instabilities of ultrafine-grained titanium’, Appl. Phys. Lett., 2001, 79, (5), 611.
5.
HuangX.: ‘Tailoring dislocation structures and mechanical properties of nanostructured metals produced by plastic deformation’, Scr. Mater., 2009, 60, (12), 1078–1082.
6.
HuangX., HansenN. and TsujiN.: ‘Hardening by annealing and softening by deformation in nanostructured metals’, Science, 2006, 312, (5771), 249–251.
7.
KamikawaN., HuangX. X. and HansenN.: ‘Dislocation-source hardening in nanostructured steel produced by severe plastic deformation’, Mater. Sci. Forum, 2010, 638–642, 1959–1964.
8.
KapoorR., SarkarA., YogiR., ShekhawatS. K., SamajdarI. and ChakravarttyJ. K.: ‘Softening of Al during multi-axial forging in a channel die’, Mater. Sci. Eng. A, 2013, A560, 404–412.
9.
YangZ. N., ZhangF. C., XiaoY. Y. and YanZ. G.: ‘Dynamic recovery: The explanation for strain-softening behaviour in Zr–2.3Nb alloy’, Scr. Mater., 2012, 67, (12), 959–962.
10.
MompiouF., CaillardD., LegrosM. and MughrabiH.: ‘In situ TEM observations of reverse dislocation motion upon unloading in tensile-deformed UFG aluminium’, Acta Mater., 2012, 60, (8), 3402–3414.
11.
TeradaD., HoudaH. and TsujiN.: ‘Effect of strain on “hardening by annealing and softening by deformation” phenomena in ultra-fine grained aluminum’, J. Mater. Sci., 2008, 43, (23–24), 7331–7337.
12.
HuangX., KamikawaN. and HansenN.: ‘Strengthening mechanisms in nanostructured aluminum’, Mater. Sci. Eng. A, 2008, A483–A484, 102–104.
13.
ValievR.: ‘The effect of annealing on tensile deformation behavior of nanostructured SPD titanium’, Scr. Mater., 2003, 49, (7), 669–674.
14.
WangY. M., ChengS., WeiQ. M., MaE., NiehT. G. and HamzaA.: ‘Effects of annealing and impurities on tensile properties of electrodeposited nanocrystalline Ni’, Scr. Mater., 2004, 51, (11), 1023–1028.
15.
ZengW., ShenY., ZhangN., HuangX., WangJ., TangG. and ShanA.: ‘Rapid hardening induced by electric pulse annealing in nanostructured pure aluminum’, Scr. Mater., 2012, 66, (3–4), 147–150.
16.
SprecherA. F., MannanS. L. and ConradH.: ‘Overview no. 49 on the mechanisms for the electroplastic effect in metals’, Acta Mater., 1986, 37, (7), 1145–1162.
17.
SuoZ.: ‘Dislocation climb in the electron wind’, Mater. Res. Soc. Symp. Proc., 1994, 338, 379–390.
18.
ZuevL. B., GromovV. E. and GurevichL. I.: ‘The effect of electric current pulses on the dislocation mobility in zinc single crystals’, Phys. Status Solidi A, 1990, 121A, 437–443.
19.
ConradH.: ‘Electroplasticity in metals and ceramics’, Mater. Sci. Eng. A, 2000, A287, 276–287.
20.
ConradH.: ‘Thermally activated plastic flow of metals and ceramics with an electric field or current’, Mater. Sci. Eng. A, 2002, A322, 100–107.
21.
ZhouY., GuoJ., ZhangW. and HeG.: ‘Influence of electropulsing on nucleation during phase transformation’, J. Mater. Res., 2002, 17, 3012–3014.
22.
ZhouY., XiaoS. and GuoJ.: ‘Recrystallized microstructure in cold worked brass produced by electropulsing treatment’, Mater. Lett., 2004, 58, (12–13), 1948–1951.
23.
ConradH., KaramN., MannanS. and SprecherA. F.: ‘Effect of electric current pulses on the recrystallization kinetics of copper’, Scr. Mater., 1988, 22, 235–238.
24.
DuX. N., YinS. M., LiuS. C., WangB. Q. and GuoJ. D.: ‘Effect of the electropulsing on mechanical properties and microstructure of an ECAPed AZ31 Mg alloy’, J. Mater. Res., 2011, 23, (06), 1570–1577.
25.
ZhouY., ZhangW., SuiM., LiD., HeG. and GuoJ.: ‘Formation of a nanostructure in a low-carbon steel under high current density electropulsing’, J. Mater. Res., 2002, 17, 921–924.
26.
ZhangW., SuiM. L., ZhouY. Z. and LiD. X.: ‘Evolution of microstructures in materials induced by electropulsing’, Micron, 2003, 34, (3–5), 189–198.
27.
SilveiraV. L. A., PortoM. F. S. and MannheimerW. A.: ‘Electroplastic effect in copper subjected to low density electric current’, Scr. Met., 1981, 15, (8), 945–950.
