The effect of Cu addition on the liquid phase separation and macrosegregation of Fe0·42Sn0·58 immiscible alloy was investigated based on thermal analysis, microstructural observations, thermodynamic and dynamic calculations. By increasing the Cu content, a structure with drastically diminished or even free of macrosegregation was realised. It revealed that Cu alloying has reduced the Gibbs free energy of mixing and temperature dependent coefficient of interfacial tension of liquids, thus depressing not only the frequency of collision and coagulation of the minor phase globules but also the liquid phase separation. As a viable and convenient means, alloying shows promise in obtaining homogeneous structure of immiscible materials.
YanN., WangW. L. and WeiB.: ‘Complex phase separation of ternary Co–Cu–Pb alloy under containerless processing condition’, J. Alloys Compd, 2013, 558, 109–116.
3.
SilvaA. P., SpinelliJ. E., Mangelinck-NoëlN. and GarciaA.: ‘Microstructural development during transient directional solidification of hypermonotectic Al–Bi alloys’, Mater. Des., 2010, 31, 4584–4591.
4.
WuM. H., LudwigA. and RatkeL.: ‘Modeling of Marangoni-induced droplet motion and melt convection during solidification of hypermonotectic alloys’, Metall. Mater. Trans. A, 2003, 34A, 3009–3019.
5.
FanZ., JiS. and ZhangJ.: ‘Processing of immiscible metallic alloys by rheomixing process’, Mater. Sci. Technol., 2001, 17, 837–842.
6.
GuoJ. J., LiuY., JiaJ., SuY. Q., DingH. S., ZhaoJ. Z. and XueX.: ‘Coarsening mode and microstructure evolution of Al–In hypermonotectic alloy during rapidly cooling process’, Scr. Mater., 2001, 45, 1197–1204.
7.
FangX. and FanZ.: ‘Rheo-diecasting of Al–Si–Pb immiscible alloys’, Scr. Mater., 2006, 54, 789–793.
8.
AhlbornH. and LÖhbergK.: Proc. 17th Aerospace Sciences Meet., New Orleans, LA, USA, January 1979, American Institute of Aeronautics and Astronautics, 3–7.
9.
WangW. H.: ‘Roles of minor additions in formation and properties of bulk metallic glasses’, Prog. Mater. Sci., 2007, 52, 540–596.
10.
LiJ. Q., MaB. Q., MinS., LeeJ., YuanZ. F. and ZangL. K.: ‘Effect of Ce addition on macroscopic core-shell structure of Cu–Sn–Bi immiscible alloy’, Mater. Lett., 2010, 64, 814–816.
11.
SunZ., SongX. P., HuZ. D., LiangG. Y., YangS. and CochraneR. F.: ‘Effects of Ni addition on liquid phase separation of Cu–Co alloys’, J. Alloys Compd, 2001, 319, 276–279.
12.
SunZ., GuoJ., SongX. P., ZhuY. M. and LiY.: ‘Effects of Zr addition on the liquid phase separation and the microstructures of Cu–Cr ribbons with 18–22 at. Cr’, J. Alloys Compd, 2008, 455, 243–248.
13.
WangC. P., LiuX. J., OhnumaI., KainumaR. and IshidaK.: ‘Formation of immiscible alloy powders with egg-type microstructure’, Science, 2002, 297, 990–993.
14.
KoziełT., KedzierskiZ., Zielińska-LipiecA. and ZiewiecK.: ‘The microstructure of liquid immiscible Fe–Cu-based in situ formed amorphous/crystalline composite’, Scr. Mater., 2006, 54, 1991–1995.
15.
MassalskiT. B., MurrayJ. L., BennettL. H. and BakerH.: ‘Binary alloy phase diagrams’, 1110; 1986, New York, ASM International.
16.
LuoB. C., LiuX. R. and WeiB.: ‘Macroscopic liquid phase separation of Fe–Sn immiscible alloy investigated by both experiment and simulation’, J. Appl. Phys., 2009, 106, 053523–053523-8.
17.
DaiR., ZhangS. G., GuoX. and LiJ. G.: ‘Formation of core-type microstructure in Al–Bi monotectic alloys’, Mater. Lett., 2011, 65, 322–325.
18.
DaiR., ZhangS. G., LiY. B., GuoX. and LiJ. G.: ‘Phase separation and formation of core-type microstructure of Al–65·5mass Bi immiscible alloys’, J. Alloys Compd, 2011, 509, 2289–2293.
19.
ZhaoJ. Z.: ‘Formation of the minor phase shell on the surface of hypermonotectic alloy powders’, Scr. Mater., 2006, 54, 247–250.
20.
KabanI., CuriottoS., ChatainD. and HoyerW.: ‘Surfaces, interfaces and phase transitions in Al–In monotectic alloys’, Acta Mater., 2010, 58, 3406–3414.
21.
DaiR., ZhangS. G. and LiJ. G.: ‘One-step fabrication of Al/Sn–Bi core–shell spheres via phase separation’, J. Electron. Mater., 2011, 12, 2458–2464.
22.
KumarK. C. H., WollantsP. and DelaeyL.: ‘Thermodynamic evaluation of Fe–Sn phase diagram’, Calphad, 1996, 20, 139–149.
23.
MiettinenJ.: ‘Thermodynamic description of the Cu–Fe–Sn system at the Cu–Fe side’, Calphad, 2008, 32, 500–505.
24.
YoungN. O., GoldsteinJ. S. and BlockM. J.: ‘The motion of bubbles in a vertical temperature gradient’, J. Fluid Mech., 1959, 6, 350–356.
25.
CahnJ. W. and HilliardJ. H.: ‘Free energy of a nonuniform system. I. Interfacial free energy’, J. Chem. Phys., 1958, 28, 258–267.
26.
RaghavanV.: ‘Phase diagrams of ternary iron alloys’, Part 6B, 768–773; 1992, Calcutta, Indian Institute of Metals.
