Abstract
A comparative study on fatigue resistance of thin aluminium bearing linings (supported by harder backing steel layers) produced by high velocity oxyfuel (HVOF) spray coating and conventional roll bonding (RB) processes has shown that the former is superior to the latter with similar lining composition (Al–20%Sn–1%Cu–0·25%Mn) when compared on the basis of oscillating lining surface strains under a three point bend test condition. In terms of the integrity of the multilayered bearing system under oscillating stresses, HVOF lining appeared to show worse fatigue resistance, due to poor/brittle bond between the lining and the backing steel layer resulting in the detachment of the lining from the backing layer. The newly developed RB alloy with reduced Sn content (Al–6·5Sn–2·5Si–1Ni–1Cu–0·25Mn) and scattered intermetallics showed higher fatigue resistance than the HVOF and previous RB systems. This was linked to delayed initiation of short cracks leading to a longer overall lifetime compared to all other systems.
Keywords
Get full access to this article
View all access options for this article.