Review of pipeline coating systems from an operator's perspective

Abstract

Over the past 40 years, pipeline integrity has been maintained by the simultaneous application of protective coatings and cathodic protection (CP). There have been significant developments in pipeline coating technology over the last 30 years as the traditional coating systems such as coal tar enamel, asphalt and single- and two-layer polyethylene (PE) coatings have been replaced in favour of coatings such as single and dual layer fusion bonded epoxy and three-layer PE and polypropylene. New coating technologies inevitably bring with them new problems for pipeline operators. The present paper reviews the transition from the more traditional coating systems to the second and third generation of pipeline coatings and discusses the new challenges that pipeline operators face. The difficulties of selecting field joint coatings with similar performance to the newer mainline coating systems will also be discussed, as well as issues related to electrical interference (ac and dc) and CP shielding that have become more of a concern because of the high integrity and dielectric strength of some modern coatings. Lessons learned over the years will be reiterated, and how far the pipeline coatings industry has progressed will be reflected upon.

Keywords

Fusion bonded epoxy (FBE)Coal tar enamel (CTE)Asphalt Three-layer polyolefins Three-layer PP Cathodic protection Pipeline

Get full access to this article

View all access options for this article.

References

‘Coal tar protective coatings and linings for steel water pipelines – enamel and tape – hot applied’

American Water Works Association Standard, ANSI/AWWA C203-91; 1991.

Wilmott

and Grimshaw

: ‘Developments in low application temperature FBE for pipelines’ 16th International Conference on Pipeline Protection, November 2-4, 2005..

Tandon

K. K.

Swamy

G. V.

and Saha

: ‘Performance of three layer polyethylene coatings on a cross country pipeline – a case study’ 14th International Conference on Pipeline Protection, October 2-4, 2001..

Roche

M. G.

: ‘An experience in offshore pipeline coatings’ NACE Corrosion Conference, 2004..

Fore

and Varughese

: ‘First generation of FBE coatings – Performance after 30 years of service – A case study’ Paper no. 06045, NACE Corrosion; 2006..

Thompson

: ‘Coating and backfill system optimisation’ PRCI Catalog no. L52208, May 2004..

Batte

A. D.

Fessler

R. R.

Marr

J. E.

and Rapp

J. E.

: ‘Managing the threat of SCC in gas transmission pipelines’ 9th International Pipeline Conference IPC 2012, September 24-28, 2012..

Beavers

J. A.

and Thompson

N. G.

: ‘Corrosion beneath disbonded pipeline coatings’ Mater. Performance 1997 36, (1), 13–19.

Sloterdijk

and Boekholt

: ‘External MIC leads to reformulation of inspection program’ 13th Biennial Meeting of EPRG and PRCI, Groningen; 2000.

10.

Wakelin

G. R.

and Sheldon

: ‘Investigation and mitigation of AC corrosion on a 300 mm diameter natural gas pipeline’ Paper 4205, NACE Corrosion; 2004.

11.

Eyre

Ellis

R. A.

and Hibberd

: ‘AC corrosion investigation and mitigation on the North West ethylene pipeline’ UK Corrosion; 2002.

12.

Hanson

and Smart

: ‘AC corrosion on a pipeline located in an HVAC utility corridor’ Paper 4209, NACE Corrosion; 2004.