The aim of this work is to investigate the corrosion behaviour of superheater materials below deposited ashes in biomass combusting atmospheres. The materials were exposed in three different settings (without deposits, with filter ash and with cyclone ash). Exposure tests were carried out with variation of water and HCl content for 360 h at 535°C. The HCl addition led to higher mass losses of materials than those without HCl addition. The rate of mass loss is proportional to the deposition aggressiveness and water content in the HCl containing atmospheres. NiCr rich superalloys are more resistant than austenitic and ferritic steels.
JohanssonT. B.KellyH. and ReddyA. N.‘Renewable energy sources for fuel and electricity’170; 2000BeijingPetroleum Industry Press.
2.
GielenD. J.de FeberM. A. P. C. and BosA. J. M.: Energy Policy200029291.
3.
LarsonE. D.: Energy Environ., 19938567.
4.
‘Energy, environment and sustainable development, Directorate-General for Research — biomass, an energy resource for the European Union,’ Community research, European Commission, Brussels, Belgium, 2000.
5.
ChenG.AndriesJ.SpliethoffH.FangM. and P. J. van de Enden: Solar Energy200476345.
6.
NielsenH. P.FrandsenF. J.Dam-JohansenK. and BaxterL. L.: Progr. Energy Combust. Sci200026283.
7.
ChaS.-C. and SpiegelM.: Corrosion200561, (8), 743–750.
8.
MichelsenH. P.FrandsenF.Dam-johansenK. and LarsenO. H.: Fuel Process. Technol19985495.
9.
MontgomeryM. and LarsenO. H.: Mater. Corros., 200253185.
10.
LiuC.LittleJ.HendersonP. and LjungP.: J. Mater. Sci200136, (4), 1015.
11.
HendersonP.KarlssonA.DaviesC.RademakersP.CiznerJ.FormanekB.GäranssonK. and OakeyJ.: ‘Materials for advanced power engineering 2002’LiegeForschungszentrum Jälich2002.
12.
PetterssonJ.PetterssonC.AstemanH.SvenssonJ.-E. and JohanssonL.-G.: Mater. Sci Forum2004461–464965.
13.
ChaS.-C. and SpiegelM.: Mater. Sci. Forum2004461–4641055.
14.
ChaS.-C. and SpiegelM.: PowerPlant Chem., 2005, 7, (2), 112–118.
15.
ChaS.-C. and SpiegelM.: Mater. Corros., 200657, (2), 159–164.
16.
ChaS.-C. and SpiegelM.: Corros. Eng. Sci. Technol200540, (3), 249–254.
17.
NielsenH. P.BaxterL. L.SclippabG.MoreyC.FrandsenF. J. and Dam-JohansenK.: Fuel200079131.
18.
BaxterL. L.MilesT. R.MilesT. R.JrJenkinsB. M.DaytonD.MilneT.BryersR. W. and OdenL. L.‘The behaviour of inorganic material in biomass-fired power boilers — field and laboratory experiences’ Vol. II; 1996Golden, CONational Renewable Energy Laboratory.
19.
SanderB.: Biomass Bioenergy1997122177.
20.
UusitaloM. A.VuoristoP. M. J. and T. A. Mäntylä: Mater. Sci Eng., 2003346168.
21.
SrodaS.MäkipääM.ChaS.-C. and SpiegelM.: Mater. Corros., 200657, (2), 176–181.
22.
ChaS.-C.: Mater. Corros., 200653(2)(in press).
23.
SalmenojaK.: ‘Field and laboratory studies on chlorine-induced corrosion in boilers fired with biofuels’Academic dissertationAbo Akademi, Turku2000.
24.
GrabkeH. J.ReeseE. and SpiegelM.: Corros. Sci1995371023.
25.
GrabkeH. J.ReeseE. and SpiegelM.: Molten Salt Forum19985–6405.
26.
ZahsA.SpiegelM. and GrabkeH. J.: Corros. Sci., 200042.
27.
KofstadP.: ‘High temperature corrosion’; 1988New York.
28.
SalmenojaK. and K. Makelä: TAPPI J., 199982161.
29.
HiramatsuN.UematsuY.TanakaT. and KinugasaM.: Mater. Sci. Eng., 1989120319.
30.
KawaharaY.OritaN.NakamuraM.AyukawaS. and HosodaT.: Proc. Conf. Corrosion'99San Antonio, TX, USA April 1999NACE International paper 91.
31.
HaanappelV. A. C.FransenT. and GellingsP. J.: High Temp. Mater. Process., 19921067.
32.
AnderssonP.NorellM. and GautheronR.: Proc. 6th Conf. on ‘High temperature corrosion and protection of materials’Les Embiez, France May 2004CEFRACOR, ORNL, EPRT, Univ Nancy I.
