Abstract
Liquid ejections from gas stirred melts can be classified into small film and jet droplets caused by bubble bursting and larger splashes resulting from gas channels formed at higher exiting gas velocities. In view of the conditions in ladle metallurgy, experimental investigations were carried out at moderate to low gas flowrates in an arc heated, bottom stirred 150 kg steel melting furnace and an 80 L water tank. Droplets were collected at different heights above the melt level, while gas flowrates, viscosities, surface tensions, and slag layer thickness were varied. The number of steel droplets collected decreased greatly with height (in the range 30-110 mm) and with size (in the range 0·1-1·8 mm). Calculations showed that the entrainment of droplets is strongly influenced by the velocity of upward flowing gases. While at low flowrates typical for secondary metallurgy (0·1 m s -1), only droplets <50 μm will be entrained, BOF (basic oxygen furnace) typical flowrates (20-50 m s -1) will cause particles up to 500 μm to be carried into the dust removal systems. Higher surface tensions resulted in increased droplet ejection, while higher viscosities led to a decreasing quantity of ejected melt. Slag layers led to a decrease in the ejection of steel droplets and to an increase in ejected slag but they did not completely stop steel ejection, because gas bubbles appear to entrain steel drops when they rise through the slag layer. Bubble bursting in a pure slag system caused large but few slag droplets due to the high viscosity of the slag as compared to the steel melt.
Get full access to this article
View all access options for this article.