Professor Tom Bell dedicated himself to the establishment of the discipline of surface engineering and contributed greatly to the development of surface engineering in China. This paper briefly overviews the four important stages in the development of surface engineering in China, i.e. single surface engineering, duplex surface engineering, nanosurface engineering and automation.
‘Editorial: Director of the Britain Surface Engineering — Professor T. Bell visits Beijing’, Chin. Surf Eng., 1989, 4, 1–2.
2.
XuB.-S., LiuS.-C. and WangH.-D.: ‘Developing remanufactur-ing, constructing cycle economy and building saving-oriented society’, J. Cent. South Univ. Technot, 2005, 12, (S2), 1–6.
3.
XuB.-S.: ‘Surface engineering and maintenance’; 1996, Beijing, Mechanical Industrial Press.
4.
XuB.-S.: ‘Magic surface engineering’; 2000, Beijing, Tsinghua University Press.
5.
XuB.-S., WangH.-D. and LiangX.-B.: ‘The good maintenance Technologies based on nano-surface engineering’, in Proc. Int. Conf. on ‘Intelligent maintenance systems’, 457–466; 2003, Changsha, National University of Defense Technology Press.
6.
XuB.-S., LiangX.-B., DongS.-Y. and XuY.: ‘Progress of nano-surface engineering’, Int. J. Mater. Prod. Technol, 2003, 18, (4), 338–343.
7.
XuB.-S., WangH.-D., DongS.-Y. and JiangB.: ‘Fretting wear-resistance of Ni-base electro-brush plating coating reinforced by nano-alumina grains’, Mater. Lett., 2006, 60, (5), 710–713.
8.
XuB.-S.: ‘Nano surface engineering’; 2004, Beijing, Chemical Industrial Press.
TuW.-Y., XuB.-S. and DongS.-Y.: ‘Chemical and electrocata-lytical interaction: influence of non-electroactive ceramic nanopar-tides on nickel electrodeposition and composite coating’, J. Mater. Sci., 2008, 43, (3), 2259–2265.
11.
ShiP.-J., XuB.-S., XuY., QiaoY.-L. and LiuQ.: ‘Tribological behaviour of oil-soluble organo-molybdenum compound as lubri-cating additives’, Trans. Nonferr. Met. Soc. China, 2004, 14, (S2), 386–390.
12.
XuB.-S.: ‘Remanufacturing engineering and automation in surface engineering Technology’, Key Eng. Mater., 2008, 373-374, 1–11.
13.
BaiJ.-Y., ChenY.-X., ChengJ.-B., LiangX.-B. and XuB.-S.: ‘An automatic high velocity arc spraying system’, Key Eng. Mater., 2008, 373-374, 89–92.
14.
WuB., XuB.-S., ZhangB. and LvY.-H.: ‘Preparation and properties of Ni/nano-A1203 composite coatings by automatic brush plating’, Surf Coat. Technot, 2007, 201, (16-17), 6933–6939.
