Abstract
The effect of the microstructural properties on the mechanical properties of welding thermal cycles and post-weld heat treatment of the heat affected zone (HAZ) in 2024-T3 aluminium alloy has been investigated. Gleeble HAZ simulation, differential scanning calorimetry, TEM and tensile test have been utilised to investigate the regions representative of HAZ microstructures. The decay of strength in the weld HAZ is primarily due to the precipitation and coarsening of stable S phases. The welded HAZ in the region at peak temperature of 414°C has the lowest strength after natural aged temper. Post-weld T81 artificial aging (PWAA-T81) heat treatment at 190°C for 12 h has no effect on improving the HAZ strength; the HAZ strength of 2024-T3 alloy obtained by PWAA-T81 treatment is less than that obtained by natural aging, and its lowest strength is shifted to the region of the peak temperature, which is 452°C. Scanning electron microscopy observation reveals that the fracture mode changes from transgranular to intergranular failure when the 2024 specimen is exposed to a thermal cycle up to a peak temperature of 550°C. This is caused by the liquation of grain boundary segregates or formation of a eutectic structure while the specimen is subjected to high temperature thermal cycles during welding, which results in a decrease in the strength and ductility of the grain boundary. It is also shown that the decrease in ductility in this high temperature HAZ cannot be improved using the PWAA-T81 heat treatment.
Keywords
Get full access to this article
View all access options for this article.