Abstract
In this paper, the failure behaviour of similar and dissimilar resistance spot welded joints of low carbon and austenitic stainless steel sheets was studied under tensile shear test with attention focused on the failure mode. Results showed that the microstructure of the fusion zone and the hardness distribution across the weld have a profound effect on the failure behaviour. Similar spot welds of stainless steel sheets exhibit the highest tendency to fail in interfacial failure mode, compared to low carbon steel similar spot welds and dissimilar low carbon and stainless steel spot welds. This behaviour is explained by the consideration of pullout failure location and hardness profile characteristics of each joint. It was shown that the failure mode transition is controlled by the hardness ratio of the fusion zone and the pullout failure location. In the case of dissimilar resistance spot welding, the hardness of the fusion zone which is governed by the dilution between two base metals, and the fusion zone size of the low carbon steel side are the dominant factors determining the failure mode of the joint.
Get full access to this article
View all access options for this article.