Evaluation of changes in X-ray elastic constants and residual stress as a function of cold rolling of austenitic steels

Abstract

Austenitic steels rapidly attain high mechanical strength when subjected to cold working. The heterogeneous plastic deformation produced in cross section of the specimen, development of preferred orientation and martensitic transformation contribute to the occurrence of residual stress in cold worked steels. AISI 304 and 316 steels were cold rolled at room temperature from 10% up to 70% deformations in steps of 10%. The formation and sigmoidal growth of martensite caused by cold rolling (CR) 304 steel was studied by X-ray diffraction. The residual stresses generated were evaluated in both the austenite and martensite phases using sin² ψ technique. The accurate determination of residual stress by X-ray diffraction requires experimental determination of X-ray elastic constants for both the austenite and martensite phases. The changes in X-ray elastic constants as a function of CR of 304 and 316 steels were measured and their effect on residual stress values was established. The results show that tensile stress was generated initially on cold working in the austenite phase in both steels and in the dominant martensite phase in 304 steel, which decreases, passes through zero and becomes compressive at higher deformations. X-ray elastic constants were found to decrease in all cases and a maximum reduction of 15% was found.