Abstract
Atomic force microscopy (AFM) in tapping mode has been used to characterise surface damage induced during the scratch test in ethylene - propylene diblock copolymers. The AFM enabled prediction of the deformation resistance of two different types of copolymer. The undeformed surface microstructure of the two copolymers (designated EP-M and EP-TC) was distinguished by differences in arrangement (regular or irregular) of fibrils, depending on their melt flow conditions. Type EP-M is a copolymer with long chains obtained by low melt flow rate, whereas EP-TC is a short chain copolymer with high melt flow rate. The microfibrils in both copolymers exhibited small kinks/nodules. Atomic force nanoscale images provided details of microfibrils containing molecular chains. The long chain EP-M copolymer exhibited non-uniformity in the alignment of molecular chains in comparison with short chain EP-TC. Surface deformation induced by the scratch test led to the formation of parabolic scratch tracks. The average surface height and peak - valley height of a track (considered a measure of the depth of the induced scratch) suggested that short chain EP-TC copolymer is more resistant to mechanically induced surface damage in comparison with long chain EP-M copolymer. Also, the average thickness of track was more for EP-TC, implying that the density of tracks/area is more in EP-M than in EP-TC, consistent with scanning electron microscope observations. Scanning electron microscopy investigations suggested localised plastic flow of material in the region surrounding the track, involving the formation of voids. Also, a comparative assessment of scratch damage was done, in terms of average surface height of the plastically deformed region, in relation to homopolymer and isotactic polypropylenes under identical test conditions.
Get full access to this article
View all access options for this article.