Low cycle fatigue resistance of Al–Li alloys

Abstract

Low cycle fatigue (LCF) resistance data from binary Al–Li, ternary Al–Li–Cu, and quaternary Al–Li–Cu–Mg alloys have been compiled and discussed. The LCF resistance is measured in terms of the variation of the number of reversals to failure 2N _fwith the plastic strain amplitude Δɛ _p /2 as well as a modified average plastic strain energy per cycle (ΔW _p)_modified, obtained at different applied total strain amplitudes (Δɛ _t /2). The data show the effects of microstructural features, namely dominant strengthening precipitates and the degree of recrystallisation as well as crystallographic texture. Lithium content, when in excess of 2·5 wt-%in aluminium decreases the low cycle fatigue resistance the most. The degree of aging, the degree of recrystallisation, and the degree of texture also influence the LCF resistance; among which the effect of the degree of aging is the most pronounced. The effects of lithium content in aluminium solid solution and strengthening precipitates obtainable by the change in the Li/Cu ratio are found to be marginal. Based on a modified total cyclic plastic strain energy till fracture, it is shown that most of the Al–Li alloys exhibit degradation in their LCF resistance in both hypotransition (higher fatigue lives) and hypertransition (lower fatigue lives) regions. Such degradation is attributed to the combined effects of mechanical fatigue, strain localisation through dislocation–precipitate interaction, environmental effects, and finally strain localisation through the high angle grain boundaries. In comparison with the currently used 2XXX and 7XXX series aluminium alloys, Al–Li alloys require substantial improvement before they can be considered for fatigue critical applications.