Abstract
We compared patient satisfaction and clinical effectiveness of 3D-printed splints made of photopolymer resin to conventional fibre glass casts in treating distal radial fractures. A total of 39 patients with minimally displaced distal radius fractures were included and randomized. Of them, 20 were immobilized in a fibre glass cast and 19 in a 3D-printed forearm splint. The 3D-printed splints were custom-designed based on forearm surface scanning with a handheld device and printed in-house using digital light processing printing technology. Patient satisfaction and clinical effectiveness were assessed with questionnaires 1 and 6 weeks after the initiation of immobilization. Fracture healing, pain, range of motion, grip strength and the DASH and PRWE scores were assessed up to 1-year follow-up. 3D-printed splints proved to be equally well tolerated by the patients and equally clinically effective as conventional fibre glass casts although there was a higher rate of minor complications. 3D-printed splints present a safe alternative, especially in young, active patients, for non-operative treatment of distal radial fractures.
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
