Thermal performance optimization of building floors under air-conditioning intermittent operation by numerical simulation

Abstract

Under air-conditioning intermittent operation, there may be the large difference of air temperatures in two adjacent rooms due to different operation behavior, and thereby, interior envelops may cause great heat loss. Under this condition, floors may become the most vulnerable spot of the room heat preservation due to their large proportion in interior envelops and poor thermal insulation. To optimize the thermal performance of floors, three floor models were built to compare their thermal performance characteristics under air-conditioning intermittent operation, while a heat transfer model was built by the finite volume method and verified by experimental data. The results showed that an expanded polystyrene layer located close to the upper surface can improve the thermal performance of the bottom floor, while the continuous integration of an air space ceiling placed close to the lower surface can improve the thermal performance of the top floor obviously. The daily cooling load formed by the cast-in-place-reinforced concrete floor integrated with the expanded polystyrene layer and the air space ceiling can reduce the daily cooling load by 53.27% and 47.00%, compared with the cast-in-place-reinforced concrete floor and the cast-in-place-reinforced concrete floor only integrated with the expanded polystyrene layer.

Keywords

Thermal performance optimization floors numerical simulation air-conditioning intermittent operation

Get full access to this article

View all access options for this article.

References

Barrios

Huelsz

Rojas

(2012) Thermal performance of envelope wall/roofs of intermittent air-conditioned rooms. Applied Thermal Engineering 40: 1–7.

Bojic

Yik

Leung

(2002) Thermal insulation of cooled spaces in high rise residential buildings in Hong Kong. Energy Conversion and Management 43(2): 165–183.

Budaiwi

Abdou

(2013) HVAC system operational strategies for reduced energy consumption in buildings with intermittent occupancy: the case of mosques. Energy Conversion and Management 73: 37–50.

Cho

Zaheer-uddin

(2003) Predictive control of intermittently operated radiant floor heating systems. Energy Conversion and Management 44: 1333–1342.

Hayase

Humphrey

JAC

Greif

(1992) A consistently formulated QUICK scheme for fast and stable convergence using finite-volume calculation procedures. Journal of Computational Physics 98: 108–118.

Hou

Meng

Gao

, et al. (2018) Effect of the insulation materials filling on the thermal performance of sintered hollow bricks under the air-conditioning intermittent running. Case Studies in Construction Materials 8: 217–225.

Ibrahim

Ghaddar

Ghali

(2012) Optimal location and thickness of insulation layers for minimizing building energy consumption. Journal of Building Performance Simulation 5(6): 384–398.

Meng

Gao

, et al. (2018a) Effect of the insulation materials filling on the thermal performance of sintered hollow bricks. Case Studies in Thermal Engineering 11: 62–70.

Zhou

Long

, et al. (2018b) Experimental study on thermal performance improvement of building envelopes by integrating with phase change material in an intermittently heated room. Sustainable Cities and Society 38: 607–615.

10.

Liu

(2009) Building Physical. Beijing, China: China Building Industry Press.

11.

Meng

(2016) Research on the dynamic thermal response characteristics of building non-transparent envelopes with the intermittent running of air-conditioning. PhD Dissertation, Sichuan University, Chengdu, China.

12.

Meng

Cao

, et al. (2018a) Numerical optimization on thermal performance characteristics of interior walls based on air-conditioning intermittent running. Case Studies in Thermal Engineering 12: 608–619.

13.

Meng

Huang

Cao

, et al. (2018b) Optimization of the wall thermal insulation characteristics based on the intermittent heating operation. Case Studies in Construction Materials 9: e00188.

14.

Meng

Luo

Gao

, et al. (2018c) Comparative analysis on thermal performance of different wall insulation forms under the air-conditioning intermittent running in summer. Applied Thermal Engineering 130: 429–438.

15.

Ministry of Housing and Urban-Rural Development (MOHURD), JGJ 134-2010 (2010) China Standard, Design Standard for Energy Efficiency Design of Residential Buildings in Hot Summer and Cold Winter Zone. Beijing, China: MOHURD.

16.

Ministry of Housing and Urban-Rural Development (MOHURD), JGJ268-2010 (2010) China Standard, Design Standard for Energy Efficiency Design of Residential Buildings in Severe Cold and Cold Zones. Beijing, China: MOHURD.

17.

Ministry of Housing and Urban-Rural Development (MOHURD), JGJ50198-2015 (2015) China Standard, Standard for Energy Efficiency Design of Public Buildings. Beijing, China: MOHURD.

18.

Patankar

(1980) Numerical heat transfer and fluid flow. New York: McGraw-Hill.

19.

Ruan

Qian

Zhu

, et al. (2015) Wall insulation effect on building energy efficiency with the intermittent and compartmental energy consuming method. Applied Mechanics and Materials 744–746: 2340–2347.

20.

Zhou

(2017) An intermittent heating strategy by predicting warm-up time for office buildings in Beijing. Energy and Buildings 155: 35–42.

21.

Sit

Deng

, et al. (2010) Thermal comfort in an office with intermittent air-conditioning running. Building Services Engineering Research and Technology 31(1): 91–100.

22.

Yan

Long

Meng

(2015) Dynamic thermal reaction analysis of wall structures in various cooling operation conditions. Energy Conversion and Management 105: 872–879.

23.

Yuan

Kang

Wang

, et al. (2017) Effects of thermal insulation characteristics on energy consumption of buildings with intermittently operated air-conditioning systems under real time varying climate conditions. Energy and Buildings 155: 559–570.

24.

Zhang

Luo

Meng

, et al. (2017) Effect of the thermal insulation layer location on wall dynamic thermal response rate under the air-conditioning intermittent running. Case Studies in Thermal Engineering 10: 79–85.

25.

Zhou

Xiao

, et al. (2017) Experimental research on thermal performance differences of building envelopes in multiple heating running conditions. Procedia Engineering 205: 628–635.