Embedded Water-based Surface Heating Part 1: Hybrid 3D Numerical Model

Abstract

A numerical simulation tool that assesses the transient operation of embedded water based surface heating systems is developed. Embedded surface heating systems and especially floor heating systems are, by far, the most common heat supply system in newly built residential buildings in, for example, Scandinavia and central Europe. The thermal system operation is influenced by the transient interaction between embedded elements, zones, construction elements, systems, gains, and weather. Thus, an integrated modeling principle, based on the International Building Physics Toolbox in Simulink©, is applied where the embedded surface heating model is represented by a module. The integrated tool is suitable for thermal system analysis of whole buildings. In particular, the embedded surface heating model simultaneously calculates the transient heat conduction that occurs within the embedded element, based on the finite control volume method, and the fluid temperature decline based on a local quasi steady state assumption. The numerical model, which represents a section plane of the embedded construction, is verified against a commercial 2D heat transfer software in the case of a typical floor heating application.

Keywords

embedded surface heating floor heating dynamic modeling low temperature heating Simulink© modeling.

Get full access to this article

View all access options for this article.

References

Ambirajan, A. and Venkateshan, S.P. ( 1993). Accurate Determination of Diffuse View Factors Between Planar Surfaces, Int. J. Heat Mass Trans., 36(8): 2203-2208.

Awbi, H.B. and Hatton, A. ( 1999). Natural Convection From Heated Room Surfaces, Energy Build., 30(3): 233-244.

Blomberg, T. ( 1996). Heat Conduction in Two and Three Dimensions Computer Modelling of Building Physics Applications, Department of Building Technology, Building Physics, Lund University, Lund, Sweden.

Caccavelli, D. and Bedouani, B. ( 1994). Etude portant sur le dimensionnement d’un plancher chauffant à eau chaude en CIC, Rapport no 2, no GEC/DST-94.050R, CSTB, France.

CEN (1997). EN ISO 1264: Floor Heating - Systems and components, European Committee for Standardization, CEN, Europe.

CEN (2008a). EN ISO 13370: Thermal Performance of Buildings - Heat Transfer Via the Ground - Calculation Methods , European Committee for Standardization , CEN, Europe.

CEN (2008b). EN 15377: Heating Systems in Buildings - Design of Embedded Water Based Surface Heating and Cooling Systems, European Committee for Standardization , CEN, Europe.

Chantrasrisalai, C. , Ghatti, V. , Fisher, D.E. and Scheatzle, D.G. ( 2003). Experimental Validation of the Energyplus Low-Temperature Radiant Simulation, ASHRAE Trans., 109(2): 614-623.

Claesson, J. and Hagentoft, C.-E. ( 1983). In Swedish: Återvinning av Varmeförluster Från Fjärrvärmekulvertar, English title: Recovery of Heat Losses from District Heating Pipes, Husbyggnadsteknik, tekniska högskolan i Lund, Lund, Sweden.

10.

Hagentoft, C.-E. , Sasic Kalagasidis, A. , Adl-Zarrabi, B. , Roels. S. , Carmeliet, J. , Hens, H. , et al. (2004). Assessment Method of Numerical Prediction Models for Combined Heat, Air and Moisture Transfer in Building Components: Benchmarks for One-dimensional Cases, J. Therm. Envel. Build. Sci., 27(4): 327-352.

11.

Hottel, H. and Sagofirm, A. ( 1967). Radiative Transfer. McGraw-Hill , New York, United States.

12.

Karlsson, H. and Hagentoft, C.-E. ( 2005). Modelling of Long Wave Radiation Exchange in Enclosures with Building Integrated Heating, In: Proceedings of the 7th Symposium on Buildings Physics in the Nordic Countries, pp. 904-911, Reykjavík, Iceland.

13.

Karlsson, H. ( 2007). An Innovative Floor Heating Application - Transfer of Excess Heat Between Two Building Zones, In: Proceedings of the 10th International Building Performance Simulation (IBPSA) Conference , pp. 148-155, Beijing, China.

14.

Karlsson, H. ( 2008). Self-Regulating Floor Heating Systems in Low Energy Buildings , In: Proceedings of the 8th Symposium on Buildings Physics in the Nordic Countries, pp. 519- 526, Copenhagen, Denmark.

15.

Karlsson, H. ( 2010). Embedded Water-Based Surface Heating, Part 2: Experimental Validation, J. Build. Phys. (in press).

16.

Koschenz, M. and Dorer, V. ( 1999). Interaction of an Air System With Concrete Core Condition , Energy Build., 30(2): 139-145.

17.

Laouadi, A. ( 2004). Development of a Radiant Heating and Cooling Model for Building Energy Simulation Software, Build. Environ., 39(4): 421-431.

18.

Sasic Kalagasidis, A. ( 2004). HAM-Tools - An Integrated Simulation Tool for Heat, Air and Moisture Transfer Analyses in Building Physics, PhD Dissertation, Building Physics Division, Chalmers University of Technology, Göteborg, Sweden.

19.

Strand, R.K. ( 1995). Heat Source Transfer Functions and Their Application to Low Temperature Radiant Heating Systems, PhD Dissertation, University of Illinois at Urbana-Champaign, United States.

20.

Strand, R.K. and Pedersen, C.O. ( 2002). Modeling Radiant Systems in an Integrated Heat Balance Based Energy Simulation Program, ASHRAE Trans., 108(2): 979-988.

21.

The International Building Physics Toolbox, Available at: www.ibpt.org (accessed May 8, 2007).

22.

Weber, T. and Jóhannesson, G. ( 2005). An Optimized RC-Network for Thermally Activated Building Components, Build. Environ., 40(1): 1-14.

23.

Weber, T. , Johannesson, G. , Koschenz, M. , Lehmann, B. , and Baumgartner, T. ( 2005). Validation of a FEM-Program (Frequency-Domain) and a Simplified RC-Model (Time-Domain) for Thermally Activated Building Component Systems (TABS) Using Measurement Data, Energy Build., 37(7): 707-724.

24.

Weitzmann, P. ( 2004). Modelling Building Integrated Heating and Cooling Systems , PhD Dissertation, Department of Civil Engineering , Technical University of Denmark, Lyngby, Denmark.

25.

Weitzmann, P. , Kragh, J. , Roots, P. and Svendsen, S. ( 2005). Modelling Floor Heating Systems Using a Validated Two-Dimensional Ground-Coupled Numerical Model, Build. Environ. , 40(2): 153-163.

26.

Wit, M. ( 2002). WAVO a Simulation Model for the Thermal and Hygric Performance of a Building, Eindhoven University of Technology , The Netherlands.

27.

Woloszyn, M. and Rode, C. ( 2008). Annex 41 Whole Building Heat, Air, Moisture Response - Modelling Principles and Common Exercises, International Energy Agency (Exco ECBCS).