Ventilation Measured in the Wall Cavities of High Moisture Risk Buildings

Abstract

New building designs following the New Zealand Building Code Approved Documents complete a 'risk matrix' of climate and building design factors with associated 'risk scores' to guide the selection of wall cladding and cavity design. The risk matrix is briefly described in this paper, along with cavity ventilation results measured with a continuous emission carbon dioxide tracer method. Ventilation rates in a selection of wall cavities are compared with ventilation rates calculated from wind pressures and vent opening sizes. Fan pressurization methods are used to measure the effective leakage areas of infiltration paths because these contribute significantly to ventilation in some cavity types. Acceptable agreement between calculated and measured day average ventilation rates has been achieved in a range of water-managed cavities from drainage planes to drained and ventilated brick veneer cavities with results spanning three orders of magnitude.

Keywords

water leakage risk cavity ventilation tracer-measured ventilation.

Get full access to this article

View all access options for this article.

References

Bassett, M.R. and McNeil, S. (2006). Measured Ventilation Rates in Water Managed Wall Cavities, In: Proceedings of The Third International Building Physics Conference, Montreal, pp. 403-410.

Bowen, J.J. (1976). A Wind Tunnel Investigation Using Simple Building Models to Obtain Mean Surface Wind Pressure Coefficients for Air Infiltration Estimates, Report LTR-LA-209, National Research Council of Canada, Ottawa.

Burnett, E. and Straube, J. (1995). Vents, Ventilation Drying, and Pressure Moderation , Canada Mortgage and Housing Corporation, Ottawa.

Department of Building and Housing (2005). Acceptable Solution E2/AS1 External Moisture, Wellington .

Gudum, C. (2003). Moisture Transport and Convection in Building Envelopes - Ventilation in Light Weight Outer Walls, PhD Thesis, Technical University of Denmark, www.byg.dtu.dk/under Publication R 047.

Liddament, M.W. (1986). Air Infiltration Calculation Techniques - An Applications Guide, Air Infiltration and Ventilation Centre, Bracknell.

Piñon, J.P. , Burnett, E.F.P. , Davidovic, D. and Srebric, J. (2004). The Airflow Characteristics of Ventilated Cavities in Screen Type Enclosure Wall Systems (RP-1091), Performance of Exterior Envelopes of Whole Buildings IX, ASHRAE, Atlanta.

Stovall, T.K. and Karagiozis, A. (2004). Airflow in the Ventilation Space Behind a Rainscreen Wall, Performance of Exterior Envelopes of Whole Buildings IX, ASHRAE, Atlanta.

TenWolde, A. , Carll, C. and Malinauskas, V. (1995). Airflows and Moisture Conditions in Walls of Manufactured Homes, ASTM. STP 1255: Airflow Performance of Building Envelopes, Components and Systems, American Society for Testing and Materials , Philadelphia.

10.

VanStraaten, R. and Straube, J. (2004). Field Study of Airflows behind Brick Veneers, Report on Project 1091 - Development of Design Strategies for Rainscreen and Sheathing Membrane Performance in Wood Frame Walls, ASHRAE , Atlanta.