Abstract
Contemporary one-step self-etch adhesives are often documented with interfacial droplets. The objective of this study was to research the origin of these droplets. Two HEMA-rich and one HEMA-free adhesive were applied to enamel and dentin, with the lining composite either immediately cured or cured only after 20 min. All one-step adhesives exhibited droplets at the interface; however, the droplets had two different origins. With the HEMA-free adhesives, droplets were located throughout the adhesive layer and were stable in number over time. With the HEMA-rich adhesives, the droplets were observed exclusively at the adhesive resin/composite interface, and their number increased significantly when the composite was delay-cured. Only the latter droplets caused a significant drop in bond strength after delayed curing. While the droplets in the HEMA-free one-step adhesives should be ascribed to phase separation, those observed with HEMA-rich adhesives resulted from water absorption from dentin through osmosis.
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
