Contraction Stress in Dentin Adhesives Bonded to Dentin

Abstract

Adhesives cured under constrained conditions develop contraction stresses. We hypothesized that, with dentin as a bonding substrate, the stress would reach a maximum, followed by a continuous decline. Stress development was determined with a tensilometer for two total-etch systems and two systems with self-etching primers. The adhesives were placed in a thin layer between a glass plate and a flat dentin surface pretreated with phosphoric acid or self-etching primer. After an initial maximum shortly after light-curing, the stress decreased dramatically for the total-etch systems (70%) and, to a lesser extent, for the adhesives with self-etching primers (30%). The greater stress decrease for the total-etch systems was ascribed to water and/or solvents released into the adhesives from the fully opened dentinal tubules by the pulling/sucking action of the contraction stress. This happened less with the adhesives with self-etching primers, where the tubules remained mainly closed.