Abstract
The mechanical removal of dentinal caries traditionally involves the use of tactile sensation and/or caries-indicating dyes. This study tested the hypothesis that self-limiting polymer burs are as effective as conventional carbide burs in creating substrates for dentin bonding. Carious dentin from extracted human molars was removed with carbide or polymer burs, with dental explorer hardness as the end-point for caries removal. Dentin substrates were bonded with etch-and-rinse or self-etch adhesives and prepared for microtensile bond testing and transmission electron microscopy. For each bur type, there was no difference in bond strength between adhesives. However, the polymer bur surface exhibited significantly lower bond strengths than the carbide bur, and both were lower than flat, non-carious dentin controls. TEM revealed areas of incompletely removed, denatured caries-infected dentin in the polymer bur specimens. These first-generation polymer burs might best be utilized for deep caries removal where pulpal exposure is a concern.
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
