Evaluation of the Effect of Clay Nanoparticles on Mechanical Properties of Recycled Polyethylene

Abstract

Over recent years, industrial applications of polymer/nanoclay nanocomposites have increased, because of their improved properties such as HDT, gas barrier ability, dimensional stability, mechanical properties, optical transparency, and flame retardation. In this work, we studied the mechanical properties of organically modified nanoclay (montmorillonite) dispersions in recycled film blowing extrusion grade polyethylene (rPE) matrix at different nanoclay contents. Results showed that the mechanical properties of the composites depend strongly on the nature and concentrations of nanoclay. The experimental values of the composites were compared to those obtained by using mixing laws. We showed that the mechanical properties correctly accounted for the experimental results at low concentrations of nanoclay particle. At concentrations higher than a few percentages, these laws fail to interpret the experimental results and all experimental results must take into account some parameters such as the particle size, their distribution, and the formation of agglomerates. The Experimental results of recycled polyethylene showed chain entanglement and decreased chain mobility, leading to an increase of brittleness and decreasing plastic behavior.

Keywords

Nanoclay Recycled Polyethylene Mold intercalation Layered Silicate Exfoliation

Get full access to this article

View all access options for this article.

References

Pavlidou

, and Papaspyrides

C.D.

, “A review on polymer–layered silicate nanocomposites,” Progress in Polymer Science, 33, 1119–1198, (2008).

Stoeffler

, Lafleur

P.G.

, and Denault

, “Effect of intercalating agents on clay dispersion and thermal properties in polyethylene/montmorillonite nanocomposites,” Polymer Engineering & Science, 48, 1449–1466, (2008).

Durmus

, Kasgoz

, and Macosko

C.W.

, “Linear low density polyethylene (LLDPE)/clay nanocomposites. Part I: Structural characterization and quantifying clay dispersion by melt rheology,” Polymer, 48, 4492–4502, (2007).

Hong

S.I.

, and Rhim

J.-W.

, “Preparation and properties of melt-intercalated linear low density polyethylene/clay nanocomposite films prepared by blow extrusion,” LWT - Food Science and Technology, 48, 43–51, (2012).

Benali

, Peeterbroeck

, Brocorens

, Monteverde

, Bonnaud

, Alexandre

, “Chlorinated polyethylene nanocomposites using PCL/clay nanohybrid masterbatches,” European Polymer Journal, 44, 1673–1685, (2008).

Zhang

, and Wilkie

C.A.

, “Preparation and flam ability properties of polyethylene–clay nanocomposites,” Polymer Degradation and Stability, 80, 163–169, (2003).

Zhang

, and Wilkie

C.A.

, “Polyethylene and polypropylene nanocomposites based on polymerically-modified clay containing alkylstyrene units,” Polymer, 47, 5736–5743, (2006).

Liu

S.-P.

, and Xu

J.-F.

, “Characterization and mechanical properties of high density polyethylene/silane montmorillonite nanocomposites,” International Communications in Heat and Mass Transfer, 38, 734–741, (2011).

Lipatov

Y.S.

, Nesterov

A.E.

, Ignatova

T.D.

, and Nesterov

D.A.

, “Effect of polymer–filler surface interactions on the phase separation in polymer blends,” Polymer, 43, 875–880, (2002).