Experimental study on identifying cracks of increasing size using ultrasonic excitation

Abstract

In structural health monitoring, crack identification using scattered ultrasonic waves from a crack is one of the most active research areas. Crack size estimation is important for judging the severity of the damage. If measurements are frequently performed as the crack grows, then a better estimation of crack size may be possible by analyzing sensor signals for the same crack location with different sizes. The objective of this article is to explore the relationship between the sensor signal amplitude and crack size through experiments and simulation for estimating the size. Cracks are machined into an aluminum plate and measurements are carried out with ultrasound excitation using piezoelectric transducer arrays that alternate their role as actuators or sensors. Initially, a hole of 2.5 mm diameter is drilled in the plate, and it is gradually machined to a crack with a size up to 50 mm. Signal amplitude is measured from the sensor arrays. The migration technique is used to image the crack and to find the crack location. The maximum received signal amplitude is found to vary linearly with size from simulation and this agrees with measurements with crack size up to 30 mm. The deviation between the simulation and experiment increases as the crack grows.

Keywords

structural health monitoring machined cracks migration technique crack identification size estimation

Get full access to this article

View all access options for this article.

References

Papazian

Anagnostoua

Engela

. A structural integrity prognosis system. Eng Fract Mech 2009; 76(5): 620–632.

Sohn H, Farrar CR, Hemez FM, et al. (2004). A review of structural health monitoring literature: 1996–2001. Report Number LA-13976-MS, Los Alamos National Laboratory, Los Alamos, NM.

Giurgiutiu

Structural health monitoring with piezoelectric wafer active sensors. San Diego and London: Academic Press, 2008.

Raghaven

Cesnik

CES.

. Review of guided-wave structural health monitoring. Shock Vib Digest 2007; 39(2): 91–114.

Giurgiutiu

Cuc

. Embedded NDE for structural health monitoring, damage detection, and failure prevention. Shock Vib Rev 2005; 37(2): 83–105.

Doebling

Farrar

Prime

MB.

. A summery review of vibration-based damage identification methods. Shock Vib Dig 1998; 30(2): 91–105.

Montalvão

Maia

NMM

Ribeiro

AMR.

. A review of vibration-based structural health monitoring with special emphasis on composite materials. Shock Vib Digest 2006; 38: 295.

Zou

Tong

Steven

GP.

. Vibration-based model-dependent damage (delamination) identification and health monitoring for composite structures - a review. J Sound Vib 2000; 230(2): 357–378.

Sodano

HA.

. Development of an automated eddy current structural health monitoring technique with an extended sensing region for corrosion detection. Struct Health Monit 2007; 6(2): 111–119.

10.

Banks

Joyner

Wincheski

Winfree

WP.

. Real time computational algorithms for eddy-current based damage detection. Inverse Prob 2002; 18(3): 795–823.

11.

Zhou

Sim

LM.

. Damage detection and assessment in fibre-reinforced composite structures with embedded fibre optic sensors—review. Smart Mater Struct 2002; 11: 925–939.

12.

Charlesworth

Temple

JAG

. Engineering applications of ultrasonic time of flight diffraction. London: Research Studies Press Ltd, 1989.

13.

Fromme P. (2002). Defect detection in plates using guided waves.Swiss Federal Institute of Technology, Doctoral Thesis.

14.

Ritdumrongkul

Fujino

. Identification of the location and size of cracks in beams by a piezoceramic actuator–sensor. Struct Control Health Monit 2007; 14: 931–943.

15.

. Crack identification in aluminum plates using Lamb wave signals of a PZT sensor network. Smart Mater Struct 2006; 15: 839–849.

16.

Michaels

TE.

. Detection of structural damage from the local temporal coherence of diffuse ultrasonic signals. IEEE Trans Ultrason Ferroelectr Freq Control 2005; 52(10): 1769–1782.

17.

Ihn

Chang

FK.

. Pitch-catch active sensing methods in structural health monitoring for aircraft structures. Struct Health Monit 2008; 7(5): 5–19.

18.

Douka

Loutridis

Trochidis

. Crack identification in plates using wavelet analysis. J Sound Vib 2004; 270: 279–295.

19.

Kerbrat

Clorennec

Prada

Royer

Cassereau

Fink

. Detection of cracks in a thin air-filled hollowcylinder by application of the DORT method to elastic components of the echo. Ultrasonics 2002; 40: 715–720.

20.

Malinowski

Wandowski

Trendafilova

Ostachowicz

. A phased array-based method for damage detection and localization in thin plates. Struct Health Monit 2009; 8: 5–15.

21.

Yan

Royer

Jr Rose

JL.

. Ultrasonic guided wave imaging techniques in structural health monitoring. J Intell Mater Syst Struct 2010; 21: 377–384.

22.

Giurgiutiu

. Tuned lamb wave excitation and detection with piezoelectric wafer active sensors for structural health monitoring. J Intell Mater Syst Struct 2005; 16: 291–305.

23.

Sicard

Chahbaz

Goyette

. Guided lamb waves and l-saft processing technique for enhanced detection and imaging of corrosion defects in plates with small depth-to-wavelength ratio. IEEE Trans Ultrason Ferroelectr Freq Control 2004; 51(10): 1287–1297.

24.

Wang

Yuan

FG.

. Damage identification in a composite plate using prestack reverse-time migration technique. Struct Health Monit 2005; 4(3): 195–211.

25.

Lin

Yuan

FG.

. Experimental study applying a migration technique in structural health monitoring. Struct Health Monit 2005; 4(4): 341–353.

26.

Zhou

Yuan

Meng

WJ.

. A pre-stack migration method for damage identification in composite structures. Smart Struct Syst 2007; 3(4): 439–454.

27.

Lin

Yuan

FG.

. Damage detection of a plate using migration technique. J Intell Mater Syst Struct 2001; 12: 469–482.

28.

Haftka

Kim

Yuan

Kwak

BM.

. Bayesian approach for structural health monitoring – application to migration technique. US-Korea Workshop on Bio-Inspired Sensor Technology and Infrastructure Monitoring 2008; Korea.

29.

Haftka

Kim

Yuan

Kwak

. Compensation for decay of signal strength in damage detection by ultrasonic imaging: application to migration technique. In: 50th AIAA/ASME/ASCE/AHS/ASC Structures, Structural Dynamics, and Materials Conference, Palm Springs, California, 2009.

30.

Bayliss

Jordan

LeMesurier

Turkel

. A fourth-order accurate finite-difference scheme for the computation of elastic waves. Bull Seismol Soc Am 1986; 76(4): 1115–1132.