Experimental Damage Identification of Carbon/Epoxy Composite Beams Using Curvature Mode Shapes

Abstract

Many composite materials and structures are susceptible to defects, which can significantly reduce the strength of structures and may grow to failure. To avoid the catastrophic failure of structures, development of a reliable method of structural health monitoring is one of the most important keys in maintaining the integrity and safety of structures. Dynamic response-based damage detection offers a simple procedure as an alternative to the conventional nondestructive evaluation techniques. However, this technique depends on the quality of measured data for its identification accuracy. In this article, experimental aspects of dynamic response-based damage detection technique on carbon/ epoxy composites are addressed. Smart piezoelectric materials are used as sensors or actuators to acquire the curvature modes of structures. These materials are surface-bonded to the beams. An impulse hammer is used as an actuating source as well. Four types of damage detection algorithms are evaluated for several possible damage configurations with two different excitation sources. The quality of damage identification with the four different detection algorithms is discussed. These experimental damage identification techniques using curvature modes and piezoelectric materials can be effectively used in damage detection and health monitoring of composite structures.

Keywords

dynamic response damage detection composite materials piezoelectric sensors and actuators composite beams

Get full access to this article

View all access options for this article.

References

Rizos, P.F. Aspragathos N. and Dimarogonas, A. (1990). Identification of crack location and magnitude in a cantilever beam from the vibration modes . Journal of Sound and Vibration, 138(3), 381–388 .

Salawu, O. (1997). Detection of structural damage through changes in frequency: a review . Engineering Structures, 19, 718–723 .

Pandey, A.K. , Biswas, M. and Samman, M.M. (1991). Damage detection from changes in curvature mode shapes . Journal of Sound and Vibration, 145(2), 321–332 .

Luo, H. and Hanagud, S. (1997). An integral equation for changes in the structural dynamics characteristics of damaged structures . Int. J. Solids Structures, 34, 4557–4579 .

Wahab, M. and De Roeck, G. (1999). Damage detection in bridges using modal curvatures: application to a real damage scenario . Journal of Sound and Vibration, 226(2), 217–235 .

Wahab, M. (2001) Effect of modal curvature on damage detection using model updating , Mechanical Systems and Signal Processing, 15(2), 439–445 .

Lestari, W. and Hanagud, S. (2001). Detection of an edge notch defect by using a single model based method . In: Proceedings of 3rd International Workshop, Stanford University, Stanford, CA, pp. 1343–1355 .

Wang, B. and Wang, B. (1997). Feasibility analysis of using piezoceramic transducers for cantilever beam model testing . Smart Materials and Structures, 6, 106–116 .

Sampaio, B. Maia, N. and Silva, J. (1999). Damage detection using the frequency-response-function curvature method . Journal of Sound and Vibration, 226(5), 1029–1042 .

10.

Farrar, C. and Jaurequi, D. (1998). Comparative study of damage identification algorithms applied to a bridge: I Experiment . Smart Materials and Structures, 7, 709–719 .

11.

Farrar, C. and Jaurequi, D. (1998). Comparative study of damage identification algorithms applied to a bridge: II Numerical study . Smart Materials and Structures, 7, 720–731 .

12.

Hamey, C.S. (2003). Dynamic response-based damage detection of composite structures using smart materials. MS Thesis, The University of Akron, Akron, OH.