To address the absence of explicit installation requirements for OPGW cables in transmission line crossing areas, a numerical simulation model of a conventional tower was developed on a finite element simulation platform to analyze the surrounding electric field distribution characteristics. The effects of different OPGW types and installation heights on the cable surface electric field strength and the 50 Hz ground-level electric field strength were systematically evaluated. The results show that the surface electric field strength of the OPGW cable is inversely proportional to its cross-sectional area at a given installation height. Comprehensive analysis indicates that the appropriate installation height of OPGW cables in crossing areas should be maintained within the range of 6–10 m.
FangYSZengFX. Technology development trend of OPGW application field. Optical Communication Research2014; 6: 48–51.
2.
ChenZFengYCLuoXL. Analysis of the difficulties and optimization strategies of OPGW operation and maintenance in Guangdong distribution network. Electr Eng2022; 21: 107–109.
3.
TeegalaSKSingalSK. Optimal costing of overhead power transmission lines using genetic algorithms. Int J Electr Power Energy Syst2016; 83: 298–308.
4.
GaoJWangLZhangQ, et al.Switching impulse discharge characteristics of UHV transmission line air gaps. IEEJ Transactions Elec Engng2019; 14(5): 735–741.
5.
SunHFChenLLiJ. Research on some key technologies of high voltage transmission. Inner Mongolia Science and Technology and Economy2023; 17: 94–96+149.
6.
SunJXZhuXJiangZG. Calculation method of collapsed tower range of power lines crossing electrified railways: a case study of Tianjin-Xingtai railway. Science, Technology and Industry2023; 23(8): 231–240.
7.
IwataMOtakaSGodaY. Melting characteristics of high-tensile, highly corrosion-resistant OPGW wires by DC arc simulating high-energy lightning strokes. Transactions of the Institute of Electrical Engineers of Japan, Vol. B (Power and Energy Division)2021; 141(6): 492–499.
8.
CarvalhoRVBonfimMJUssunaDA, et al.Distributed temperature sensing in OPGW with multiple optical fibres. IET Sci Meas Technol2019; 13(8): 1219–1223.
9.
AnWSunXTangY, et al.Experimental study on fire performance of optical cables used in utility tunnel: influence of cable spacing and heat flux. Fire Mater2023; 47(7): 884–891.
10.
IwataMOhtakaTGodaY, et al.Melting and breaking characteristics of strands of high-strength and high-corrosion-resistant OPGW due to DC arc discharge simulating high-energy lightning strike. Electr Eng Jpn2021; 214(4): e23345.
11.
Arias VelásquezRMMejía LaraJV. Ruptures in overhead ground wire — transmission line 220 kV. Eng Fail Anal2018; 87: 1–14.
12.
HuangYXuQTanQ, et al.Optimization of electric field distributions in OVS with hybrid algorithm. IEEE Sens J2019; 19(21): 9748–9754.
13.
SugawaraH. Configuration of propagator method for calculation of electron velocity distribution function in gas under crossed electric and magnetic fields. Plasma Sci Technol2019; 21(9): 094001.
14.
WangZDuanNChenJ, et al.Effect of tree quantity and distribution on the electric field under transmission lines. Appl Sci2024; 14(18): 8487.
15.
HelmMUnterrainerKGornikE. Hot-carrier quantum distribution function in crossed electric and magnetic fields. Phys Rev B1989; 39(9): 6212–6215.
16.
HuangY. Tangential electrostatic field at metal surfaces. Open Phys2023; 21(1): 20220270.
17.
LiMShiPDuL, et al.Electronic Maxwell’s equations. New J Phys2020; 22(11): 113019.
18.
FialováSPochylýF. A new formulation of Maxwell’s equations. Symmetry2021; 13(5): 868.
19.
WangLLiC. Finite element simulation of electric field of new T-junction tower for transmission line. J Phys : Conf Ser2024; 2846(1): 012041.
20.
KumarKBThomasMJ. Computation of audible noise from a 1200 kV UHV power transmission line. IEEE Trans Dielectr Electr Insul2016; 23(2): 974–978.
21.
ZhaoLXieLLiuC, et al.Corona current and audible noise characteristics of HVDC transmission lines and their relationship at high-altitude. IET Gener Transm Distrib2023; 17(15): 3399–3409.
