The effect of matrix-assisted laser desorption/ionization time-of-flight mass spectrometry instrumentation parameters on the matrix-assisted laser desorption/ionization simulated size exclusion chromatography number-mass,average-weight and polydispersity values of dextran against corresponding values obtained by size exclusion chromatography

Abstract

The matrix-assisted laser desorption/ionization simulated size exclusion chromatography (SECPC) average-number mass, weight average and polydispersity of dextran 1000 were determined by matrix-assisted laser desorption/ionization (MALDI) time-of-flight (TOF) mass spectrometry. The instrument parameters were varied and the SECPC value determined via the Bruker XMASS software was compared to the value obtained from aqueous-phase size exclusion chromatography. The aqueous-phase size exclusion chromatography values for average-number mass, weight average and polydispersity were 1223 Da, 1500 Da and 1.23 (1010 Da, 1270 Da and 1.26 from manufacturer), whereas the SECPC value varied on the instrumental parameters. The factors that had the greatest effect on the average-number mass, weight average and polydispersity were: (most effect on SECPC value) laser attenuation > matrix-analyte molar concentration > matrix-analyte molar ratios > delay extraction time > solvent-system composition > detector delay (least effect on SECPC value). The oligosaccharide signal distribution as a function of laser attenuation indicate that two distinct regions exist in dextran 1000, where one corresponds to the higher mass oligosaccharides (hexasaccharide or greater), while another region corresponds to lower oligosaccharides (tetra-saccharide). This distribution depends upon the crystallization of the biopolymer and the efficiency of desorption/ionization, which yields the SECPC value. There was broad agreement between the SECPC values and size exclusion chromatography values for dextran, although the polydispersity indicated by SECPC was less than size exclusion chromatography (1.10 vs. 1.26). It can be shown that for narrow polydisperse biopolymers the instrumental conditions are less critical in the determination of average-number mass, weight average and polydispersity, although the SECPC Mn, and weight average values are often higher than the corresponding values obtained by aqueous-phase size exclusion chromatography.

Keywords

MALDI Polydispersity SEC SECPC Mn and Mw TOF

Get full access to this article

View all access options for this article.

References

Chen

Baker

Novotny

. The use of osazones as matrices for the matrix-assisted laser desorption/ionization mass spectrometry of carbohydrates. Anal Biochem 1997; 244: 144–151.

Jackson

Yates

Scrivens

et al.

The application of matrix-assisted laser desorption/ionization combined with collision-induced dissociation to the analysis of synthetic polymers. Rapid Commun Mass Spectrom 1996; 10: 1668–1674.

Jackson

Yates

Scrivens

Green

Bateman

. Matrix-assisted laser desorption/ionization-collision induced dissociation of poly (styrene). J Am Soc Mass Spectrom 1998; 9: 269–274.

Pasch

. Functionality analysis of polymers by MALDI-MS. Polym Preprint 1996; 37: 319–320.

Perera

Kantartzoglou

Dyer

. Some characteristics of matrix-assisted UV laser desorption/ionization mass spectrometric analysis of large proteins. Int J Mass Spectrom Ion Process 1996; 156: 151–172.

Davison

Mentzer

. Polymer flooding in North Sea reservoirs. Society of Petroleum Engineers J 1982; 22: 353–362.

Roberts

Bratton

. Colloid volume expanders. Drugs 1998; 55: 621–630.

Barry

Carton

Pesci

Anselmo

Radtke

Evans

. Derivatization of Low Molecular Weight Polymers for Characterization by Matrix-assisted Laser Desorption/Ionization Time-of-flight Mass Spectrometry. Rapid Commun Mass Spectrom 1997; 11: 437–442.

Dey

Castoro

Wilkins

. Determination of molecular weight distributions of polymers by MALDI-FTMS. Anal Chem 1995; 67: 1575–1579.

10.

Montaudo

Garozzo

Montaudo

Puglisi

Samperi

. Molecular and structural characterization of polydisperse polymers and copolymers by combining MALDI-TOF mass spectrometry with GPC fractionation. Macromolecules 1995; 28: 7983–7989.

11.

Thomson

Suddaby

Rudin

et al.

Characterisation of low molecular weight polymers using matrix assisted laser desorption time-of-flight mass spectrometry. Eur Polym J 1996; 32: 239–256.

12.

Spickermann

Martin

Räder

et al.

Quantitative analysis of broad molecular weight distributions obtained by matrix-assisted laser desorption ionisation-time-of-flight mass spectrometry. Biomed Environ Mass Spectrom 1996; 2: 161–165.

13.

O'Connor

Duursma

van Rooij

et al.

Correction of time-of-flight shifted polymeric molecular weight distributions in matrix-assisted laser desorption/ionization Fourier transform mass spectrometry. Anal Chem 1997; 69: 2751–2755.

14.

Zhu

Yalcin

. Analysis of the accuracy of determining average molecular weights of narrow polydispersity polymers by matrix-assisted laser desorption ionization time-of-flight mass spectrometry. J Am Soc Mass Spectrom 1998; 9: 275–281.

15.

Montaudo

Puglisi

et al.

Characterization of polymers by matrix-assisted laser desorption/ionization time-of-flight mass spectrometry: Molecular weight estimates in samples of varying polydispersity. Rapid Commun Mass Spectrom 1995; 9: 453–460.

16.

McEwen

Jackson

Larsen

. Instrumental effects in the analysis of polymers of wide polydispersity by MALDI mass spectrometry. Int J Mass Spectrom Ion Process 1997; 160: 387–394.

17.

Jackson

Yates

Lindsay

et al.

Utilizing Time-lag Focusing Matrix-assisted Laser Desorption/Ionization Mass Spectrometry for the End Group Analysis of Synthetic Polymers. Rapid Commun Mass Spectrom 1997; 11: 520–526.

18.

Medina

Huth-Fehre

Westman

et al.

Matrix-assisted laser desorption: Dependence of the threshold fluence on analyte concentration. J Mass Spectrom 1994; 29: 207–209.