Highly oxygenated fuels can effectively reduce afterburning in diesel diffusion combustion and improve the degree of constant volume heat release in spite of increases in injection duration due to smaller heating values. The mechanism of afterburning reduction and the structural differences in the diesel fuel spray with changing the oxygen content in the fuel were investigated in a constant volume vessel and analyzed with 3D CFD simulation. The result showed that the equibalance ratio inside the spray decreased with increases in the oxygen content due to lower theoretical air-fuel ratios, promoting the spray combustion after the end of injection. Further, the combustion characteristics and the exhaust gas emissions of the oxygenated fuels were investigated in an experimental single cylinder diesel engine with modern specifications. With increasing oxygen contents, the degree of constant volume heat release increased with reductions in the afterburning, resulting in higher indicated thermal efficiencies. However, the indicated thermal efficiency showed a maximum at around 27 mass% of the oxygen in fuel and further increases in the oxygen contents resulted in lower indicated thermal efficiencies due to larger cooling losses.
MiyamotoNOgawaHNabiMN. Approaches to extremely low emissions and efficient diesel combustion with oxygenated fuels. Int J Engine Res2000; 1: 71–85.
2.
OgawaHNabiNMinamiMMiyamotoNKimB. Ultra low emissions and high performance diesel combustion with a combination of high EGR, three-way catalyst, and a highly oxygenated fuel, dimethoxy methane (DMM). SAE technical paper 2000-01-1819, 2000.
3.
NabiNMinamiMOgawaHMiyamotoN. Ultra low emission and high performance diesel combustion with highly oxygenated fuel. SAE technical paper 2000-01-0231, 2000.
4.
LeeS-WMurataYDaishoY. Spray and combustion characteristics of dimethyl ether fuel. Proc IMechE, Part D: J Automobile Engineering2005; 219: 97–102.
5.
KitamuraTItoTSendaJFujimotoH. Mechanism of smokeless diesel combustion with oxygenated fuels based on the dependence of the equivalence ration and temperature on soot particle formation. Int J Engine Res2002; 3(4): 223–248.
6.
KajitaniSChenZKonnoMRheeKT. Engine performance and exhaust characteristics of direct-injection diesel engine operated with DME. SAE technical paper 972973, 1997.
7.
PhilippDChristianB. CO2 neutral fuels in series engines - demonstration of the potential of OME with regard to efficiency and ultra-low emissions. SAE technical paper 2021-24-0061, 2021.
8.
AsadURamosMTjongJ. An investigation of OME3-diesel fuel blend on a multi-cylinder compression ignition engine. SAE technical paper 2022-01-0439, 2022.
9.
HolzerAGuenthnerM. Investigation of the emission reduction potential of HVO-OME fuel blends in a single-cylinder diesel engine. SAE technical paper 2021-01-0556, 2021.
10.
DworschakPBergerVHärtlMWachtmeisterG. Neat oxymethylene ethers: combustion performance and emissions of OME2, OME3, OME4 and OME5 in a single-cylinder diesel engine. SAE technical paper 2020-01-0805, 2020.
11.
PastorJGarcia-OliverJMicóCTejadaF. Combustion behaviour of blends of synthetic fuels in an optical single cylinder engine. SAE technical paper 2021-24-0038, 2021.
12.
LeblancSYuXSandhuNWangM, et al. Combustion and emission characteristics of SI and HCCI combustion fueled with DME and OME. SAE technical paper 2020-01-1355, 2020.
13.
GelnerAPastoetterCBeckHHärtlM, et al. Fuel dosing on a diesel oxidation catalyst for after-treatment system heating on a heavy-duty engine powered by polyoxymethylene dimethyl ethers. SAE technical paper 2020-01-2157, 2020.
14.
PöllmannSHärtlMWachtmeisterG. Injection process of the synthetic fuel oxymethylene ether: optical analysis in a heavy-duty engine. SAE technical paper 2020-01-2144, 2020.
15.
AlexanderGHaraldBChristianPMartinHGeorgW. Ultra-low emissions of a heavy-duty engine powered with oxymethylene ethers (OME) under stationary and transient driving conditions. Int J Engine Res2022; 23(5): 738–753.
16.
SimonPMartinHGeorgW. Potential of miller timing with synthetic diesel fuels on a single cylinder heavy-duty engine. Int J Engine Res2022; 23(5): 769–780.
17.
García-OliverJMNovellaRMicóCLeon-CerianiDD. Numerical analysis of the combustion process of oxymethylene ethers as low-carbon fuels for compression ignition engines. Int J Engine Res. Epub ahead of print 21 July 2022. DOI: 10.1177/14680874221113749
18.
DominikGMarcoDLimingCPankajP, et al. Oxymethylene ether – n-dodecane blend spray combustion: experimental study and large-eddy simulations. Fuel2021; 38(2): 3417–3425.
19.
HoneckerCNeumannMGlueckSSchoenenM, et al. Optical spray investigations on OME3-5 in a constant volume high pressure chamber. SAE technical paper 2019-24-0234, 2019.
20.
SamirRJaeheunKScinichiKNishidaKOgataY. Effects of split ratio of diesel spray injection on mixture formation and combustion process. Proc IMechE, Part J: J Automobile Engineering2021; 235(14): 3404–3415.
21.
AizawaTKinoshitaTTanakaY, et al. Vortex development and heat releaseenhancement in diesel spray flame by inversed-delta injection rate shaping using TAIZAC injector. SAE technical paper 2021-24-0037, 2021.
22.
KimJKakamiSNishidaKOgataY. Effects of ratio and dwell of split injection on fuel spray and mixture formation process under evaporating, non-reacting condition. SAE technical paper 2019-01-2323, 2019.
23.
KangYYamakawaHNishidaKOgataYNishiokaY. Effect of split injection on mixture formation and combustion processes of diesel spray injected into two-dimensional piston cavity. Proc IMechE, Part J: J Automobile Engineering2017; 232(8): 1121–1136.
24.
AbdullahBMToyamaYTakaharaK, et al. Optical diagnostics of inversed-delta rate shaping diesel spray flame towards reduction of late combustion. SAE technical paper 2018-01-1793, 2018.
25.
LeeSWSimsooPDaishoY. An experimental study of diesel-fuel property effects on mixing-controlled combustion in a heavy-duty optical CI engine. Proc IMechE, Part J: J Automobile Engineering2004; 218(11): 1317–1323.
26.
PickettLMSiebersDL. Soot formation in diesel fuel jets near the lift-off length. Int J Engine Res2006; 7: 103–130.
27.
YiannisHChristopherHChristosK, et al. An investigation of the effect of post-injection schemes on soot reduction potential using optical diagnostics in a single-cylinder optical diesel engine. Int J Engine Res2017; 18: 400–411.
28.
O’ConnorJMusculusM. Effects of exhaust gas recirculation and load on soot in a heavy-duty optical diesel engine with close-coupled post injections for high-efficiency combustion phasing. Int J Engine Res2014; 15: 421–443.
29.
MancarusoEMerolaSSVagliecoBM. Study of the multi-injection combustion process in a transparent direct injection common rail diesel engine by means of optical techniques. Int J Engine Res2008; 9: 483–498.
30.
HerfatmaneshMRLuPAttarMAZhaoH. Experimental investigation into the effects of two-stage injection on fuel injection quantity, combustion and emissions in a high-speed optical common rail diesel engine. Fuel2013; 109: 137–147.
31.
FanCNishidaKOgataY. Visualization of diesel spray and combustion from lateral side of two-dimensional piston cavity in rapid compression and expansion machine, second report: effects of injection pressure and interval of split injection. Int J Engine Res2022; 23: 446–459.
32.
KamimotoTUchidaNAizawaTKondoKKuboyamaT. Diesel flame imaging and quantitative analysis of in-cylinder soot oxidation. Int J Engine Res2017; 18: 422–435.
33.
KondoKKuribayashiMSakaiKAizawaT. High-speed ultraviolet chemiluminescence imaging of late combustion in diesel spray flame. Int J Engine Res2017; 18: 93–104.
34.
BealeJCReitzRD. Modeling spray atomization with the Kelvin-Helmholtz / Rayleigh-Taylor hybrid model. Atomization Sprays1999; 9(6): 623–650.
35.
DukowiczJK. Quasi-steady droplet change in the presence of convection. Informal Report Los Alamos Scientific Laboratory, 1979, LA7997-MS.
36.
MiyoshiASakaiY. Construction of a detailed kinetic model for gasoline surrogate mixtures (in Japanese). JSAE paper 20174744, 2017.
37.
SakaiYHasegawaKMiyoshiA. Development of reduced chemical kinetics mechanism of gasoline surrogate fuel with oxygenated compounds (in Japanese). 29th Internal combustion engine symposium paper 20183155, 2018.
NaberJSiebersDCatonJWestbrookC, et al. Natural gas autoignition under diesel conditions: experiments and chemical kinetic modeling. SAE technical paper 942034, 1994.
40.
ListH. Thermodynamik der Verbrennugskraftmaschine. Wien: Julius Springer, 1939.
