In this work, the Global Energy Balance (GEB) of a 1.6 L compression ignition engine is analyzed during WLTC using a combination of experimental measurements and simulations, by means of a Virtual Engine. The energy split considers all the relevant energy terms at two starting temperatures (20°C and 7°C) and two altitudes (0 and 1000 m). It is shown that reducing ambient temperature from 20°C to −7°C decreases brake efficiency by 1% and increases fuel consumption by 4%, mainly because of the higher friction due to the higher oil viscosity, while the effect of increasing altitude 1000 m decreases brake efficiency by 0.8% and increases fuel consumption by 2.5% in the WLTC mainly due to the change in pumping. In addition, GEB shows that ambient temperature is affecting exhaust enthalpy by 4.5%, heat rejection to coolant by 2%, and heat accumulated in the block by 2.5%, while altitude does not show any remarkable variations other than pumping and break power.
JiaqiangELiuTYangWDengYGongJ. A skeletal mechanism modeling on soot emission characteristics for biodiesel surrogates with varying fatty acid methyl esters proportion. Appl Energy2016; 181: 322–331.
2.
WuGLuZXuX, et al. Numerical investigation of aeroacoustics damping performance of a Helmholtz resonator: effects of geometry, grazing and bias flow. Aerosp Sci Technol2019; 86: 191–203.
3.
LiYChenYWuGLiuJ. Experimental evaluation of water-containing isopropanol-n-butanol-ethanol and gasoline blend as a fuel candidate in spark-ignition engine. Appl Energy2018; 219(March): 42–52.
4.
GiakoumisEG. A statistical investigation of biodiesel effects on regulated exhaust emissions during transient cycles. Appl Energy2012; 98: 273–291.
5.
TriantafyllopoulosGKatsaounisDKaramitrosDNtziachristosLSamarasZ. Experimental assessment of the potential to decrease diesel NOx emissions beyond minimum requirements for Euro 6 Real Drive Emissions (RDE) compliance. Sci Total Environ2018; 618(x): 1400–1407.
6.
ParkHBaeCHaC. A comprehensive analysis of multiple injection strategies for improving diesel combustion process under cold-start conditions. Fuel2019; 255(June): 115762.
7.
JiaqiangEHanDDengY, et al. Performance enhancement of a baffle-cut heat exchanger of exhaust gas recirculation. Appl Therm Eng2018; 134(January): 86–94.
8.
JiaqiangEZhaoXXieL, et al. Performance enhancement of microwave assisted regeneration in a wall-flow diesel particulate filter based on field synergy theory. Energy2019; 169: 719–729.
9.
JiaqiangELiuGZhangZ, et al. Effect analysis on cold starting performance enhancement of a diesel engine fueled with biodiesel fuel based on an improved thermodynamic model. Appl Energy2019; 243(March): 321–335.
10.
RamadhasASXuH. Improving cold start and transient performance of automotive diesel engine at low ambient temperatures. SAE Technical Papers2016; 2016-April(April).
11.
RakopoulosCDDimaratosAMGiakoumisEGRakopoulosDC. Investigating the emissions during acceleration of a turbocharged diesel engine operating with bio-diesel or n-butanol diesel fuel blends. Energy2010; 35(12): 5173–5184.
12.
RakopoulosDGiakoumisEG. Diesel engine transient operation - principles of operation and simulation analysis. London: Springer-Verlag London Limited.
13.
RakopoulosCDGiakoumisEGHountalasDT, et al. The effect of various dynamic, thermodynamic and design parameters on the performance of a turbocharged diesel engine operating under transient load conditions. SAE Technical Paper Series2010; 1(724).
14.
European Parliament and Council of the European Union. Regulation (EC) No 852/2004 of the European Parliament and of the Council. Official J Eur Commun2004; 2006(December 2006): 1–54.
15.
MartinJArnauFPiquerasPAuñonA. Development of an integrated virtual engine model to simulate new standard testing cycles. SAE Technical Paper Series, 2018-01-1413, 2018.
16.
PayriFLopezJJPlaBBustamanteDG. Assessing the limits of downsizing in diesel engines. SAE Technical Paper Series, 2014-32-0128, 2014.
17.
GiakoumisEGRakopoulosCDDimaratosAMRakopoulosDC. Exhaust emissions of diesel engines operating under transient conditions with biodiesel fuel blends. Prog Energy Combust Sci2012; 38(5): 691–715.
18.
CuiYDengKWuJ. A direct injection diesel combustion model for use in transient condition analysis. Proc IMechE Part D: J Automobile Engineering2001; 215(9): 995–1004.
19.
PammingerMWangBHallCMVojtechRWallnerT. The impact of water injection and exhaust gas recirculation on combustion and emissions in a heavy-duty compression ignition engine operated on diesel and gasoline. Int J Engine Res2020; 21: 1555–1573.
20.
TauziaXMaiboomAKarakyHChesseP. Experimental analysis of the influence of coolant and oil temperature on combustion and emissions in an automotive diesel engine. Int J Engine Res2019; 20(2): 247–260.
21.
CárdenasMDGómezAArmasO. Pollutant emissions from starting a common rail diesel engine fueled with different biodiesel fuels. J Energy Eng2016; 142(2): E4015012.
22.
GiakoumisEGDimaratosAMRakopoulosCDRakopoulosDC. Combustion instability during starting of turbocharged diesel engine including biofuel effects. J Energy Eng2017; 143(2): 04016047.
23.
García-ContrerasRArmasOMataCVillanuevaO. Impact of gas to liquid and diesel fuels on the engine cold start. Fuel2017; 203: 298–307.
24.
DardiotisCMartiniGMarottaAManfrediU. Low-temperature cold-start gaseous emissions of late technology passenger cars. Appl Energy2013; 111: 468–478.
25.
TinprabathPHespelCChanchaonaSFoucherF. Influence of biodiesel and diesel fuel blends on the injection rate under cold conditions. Fuel2015; 144: 80–89.
26.
ParkHShinJBaeC. Spray and combustion of diesel fuel under simulated cold-start conditions at various ambient temperatures. SAE Technical Paper, 2017-24-0069, 2017.
27.
RobertsABrooksRShipwayP. Internal combustion engine cold-start efficiency: a review of the problem, causes and potential solutions. Energy Convers Manag2014; 82: 327–350.
28.
HorngRFChouHM. Effect of input energy on the emission of a motorcycle engine with an electrically heated catalyst in cold-start conditions. Appl Therm Eng2004; 24(14–15): 2017–2028.
29.
ClairotteMAdamTWZardiniAA, et al. Effects of low temperature on the cold start gaseous emissions from light duty vehicles fuelled by ethanol-blended gasoline. Appl Energy2013; 102(2013): 44–54.
30.
ChenRHChiangLBChenCNLinT-H. Cold-start emissions of an SI engine using ethanol-gasoline blended fuel. Appl Therm Eng2011; 31(8–9): 1463–1467.
31.
GumusM. Reducing cold-start emission from internal combustion engines by means of thermal energy storage system. Appl Therm Eng2009; 29(4): 652–660.
32.
DengYLiuHZhaoXJiaqiangEChenJ. Effects of cold start control strategy on cold start performance of the diesel engine based on a comprehensive preheat diesel engine model. Appl Energy2018; 210(October 2017): 279–287.
33.
LujánJMDolzVMonsalve-SerranoJMaldonadoMAB. High-pressure exhaust gas recirculation line condensation model of an internal combustion diesel engine operating at cold conditions. Int J Engine Res2019; 22(2): 407–416.
34.
LujánJMClimentHRuizSMoratalA. Influence of ambient temperature on diesel engine raw pollutants and fuel consumption in different driving cycles. Int J Engine Res2019; 20(8–9): 877–888.
35.
GalindoJDolzVMonsalve-SerranoJMaldonadoMABOdillardL. Advantages of using a cooler bypass in the low-pressure exhaust gas recirculation line of a compression ignition diesel engine operating at cold conditions. Int J Engine Res2020; 22(5): 1624–1635.
36.
KawaguchiAWakisakaYNishikawaN, et al. Thermo-swing insulation to reduce heat loss from the combustion chamber wall of a diesel engine. Int J Engine Res2019; 20(7): 805–816.
37.
LiuSShenLBiYLeiJ. Effects of altitude and fuel oxygen content on the performance of a high pressure common rail diesel engine. Fuel2014; 118: 243–249.
38.
PayriFOlmedaPMartinJCarreñoR. A new tool to perform global energy balances in DI diesel engines. SAE Int J Engine2014; 7(1): 43–59.
39.
PayriFMartinJGarciaACarreñoR. Experimental and theoretical analysis of the energy balance in a di diesel engine. SAE Technical Paper Series, 2015-01-1651, 2015.
40.
TauziaXMaiboomA. Experimental study of an automotive diesel engine efficiency when running under stoichiometric conditions. Appl Energy2013; 105: 116–124.
41.
AbedinMJMasjukiHHKalamMASanjidAAshrafur RahmanSMMasumBM. Energy balance of internal combustion engines using alternative fuels. Renew Sustain Energy Rev2013; 26: 20–33.
42.
AjavEASinghBBhattacharyaTK. Thermal balance of a single cylinder diesel engine operating on alternative fuels. Energy Convers Manage2000; 41(14): 1533–1541.
43.
DurgunOahinZ. Theoretical investigation of heat balance in direct injection (DI) diesel engines for neat diesel fuel and gasoline fumigation. Energy Convers Manage2009; 50(1): 43–51.
44.
SmithLAPrestonWHDowdGTaylorOWilkinsonKM. Application of a first law heat balance method to a turbocharged automotive diesel engine. SAE Technical Paper Series, 2009-01-2744, 2009.
45.
OlmedaPMartínJNovellaRBlanco-CaveroD. Assessing the optimum combustion under constrained conditions. Int J Engine Res2018; 21(5): 811–823.
46.
TaymazI. An experimental study of energy balance in low heat rejection diesel engine. Energy2006; 31(2–3): 364–371.
47.
JungDYongJChoiHSongHMinK. Analysis of engine temperature and energy flow in diesel engine using engine thermal management. J Mech Sci Technol27(2): 583–592.
48.
CaresanaFBilanciaMBartoliniCM. Numerical method for assessing the potential of smart engine thermal management: application to a medium-upper segment passenger car. Appl Therm Eng2011; 31(16): 3559–3568.
49.
PayriFLópezJJMartínJCarreñoR. Improvement and application of a methodology to perform the Global Energy Balance in internal combustion engines. Part 1: Global Energy Balance tool development and calibration. Energy2018; 152: 666–681.
50.
RomeroCATorregrosaAOlmedaPMartinJ. Energy balance during the warm-up of a diesel engine. SAE Technical Paper Series, 2014-01-0676, 2014.
51.
KanZHuZLouDTanPCaoZYangZ. Effects of altitude on combustion and ignition characteristics of speed-up period during cold start in a diesel engine. Energy2018; 150: 164–175.
52.
OlmedaPMartínJArnauFJArthamS. Analysis of the energy balance during world harmonized light vehicles test cycle in warmed and cold conditions using a virtual engine. Int J Engine Res2019; 21(6): 1037–1054.
53.
OlmedaPMartinJGarciaABlancoDWareyADomenechV. Evaluation of EGR effect on the global energy balance of a high speed DI diesel engine. SAE Technical Paper Series, 2016-01-0646, 2016.
54.
BenajesJOlmedaPMartínJCarreñoR. A new methodology for uncertainties characterization in combustion diagnosis and thermodynamic modelling. Appl Therm Eng2014; 71(1): 389–399.
55.
PayriFMargotXGilAMartinJ. Computational study of heat transfer to the walls of a DI diesel engine. SAE Technical Paper Series, 2005-01-0210, 2005.
56.
PayriFOlmedaPMartínJCarreñoR. Experimental analysis of the global energy balance in a di diesel engine. Appl Therm Eng2015; 89(x): 545–557.
57.
Carreño ArangoR. A comprehensive methodology to analyse the global energy balance in reciprocating internal combustion engines. [Tesis doctoral no publicada]. Universitat Politècnica de València, 2016.
58.
OlmedaPDolzVArnauFJReyes-BelmonteMA. Determination of heat flows inside turbochargers by means of a one dimensional lumped model. Math Comput Model2013; 57(7–8): 1847–1852.
59.
TorregrosaAOlmedaPDegraeuweBReyesM. A concise wall temperature model for di Diesel engines. Appl Therm Eng2006; 26(11–12): 1320–1327.
60.
DesantesJMArregleJLopezJJCronhjortA. Scaling laws for free turbulent gas jets and diesel like sprays. At Sprays2006; 16: 443–474.
61.
HamosfakidisVReitzRD. Optimization of a hydrocarbon fuel ignition model for two single component surrogates of diesel fuel. Combust Flame2003; 132(3): 433–450.
