This work explores pathways to achieve diesel-like, high-efficiency combustion with stoichiometric 3-way catalyst compatible combustion in a single-cylinder spark ignition (SI) research engine. A unique high stroke-to-bore engine design (1.5:1) with cooled exhaust gas recirculation (EGR) and high compression ratio (rc) was used to improve engine efficiency by up to 30% compared with a production turbocharged gasoline direct injection spark ignition engine. Engine experiments were conducted with both 91 RON E10 gasoline and liquified petroleum gas (LPG) (i.e. autogas) and were compared to legacy gasoline data on the production engine. Geometric compression ratio (rc) of 13.3:1 was used for both fuels with additional experiments at 16.8:1 for LPG only. Measurements of exhaust soot particle size and number concentrations were made with both fuels. Significant reduction in soot particles across the whole particle size range were achieved with LPG due to the elimination of in-cylinder liquid films. The effects of EGR, late intake valve closing (IVC) and fuel characteristics were investigated through their effects on efficiency, combustion stability and soot production. Results of 47% gross thermal efficiency, and 45% net thermal efficiency at stoichiometric engine operation, at up to 17 bar IMEP and 2000 r/min with 16.8:1 rc were achieved with LPG. Estimated brake efficiency values were compared to a contemporary medium duty diesel engine illustrating the benefits of the chosen path for achieving diesel efficiency parity.
WissinkMLSplitterDADempseyABCurranSJKaulBCSzybistJP.An assessment of thermodynamic merits for current and potential future engine operating strategies. Int J Eng Res2017; 18(1–2): 155–169.
2.
AlgerTMangoldBRobertsCGingrichJ.The interaction of fuel anti-knock index and cooled EGR on engine performance and efficiency. SAE Int J Engines2012; 5(3): 1229–1241.
3.
SzybistJPWagnonSWSplitterDPitzWJMehlM.The reduced effectiveness of EGR to mitigate knock at high loads in boosted SI engines. SAE Int J Engines2017; 10(5): 2305–2318.
4.
SzybistJPYoungquistADBaroneTL, et al. Ethanol blends and engine operating strategy effects on light-duty spark-ignition engine particle emissions. Energy Fuels2011; 25(11): 4977–4985.
5.
JatanaGSSplitterDAKaulBSzybistJP.Fuel property effects on low-speed pre-ignition. Fuel2018; 230: 474–482.
6.
ChapmanEDavisRStudzinskiWGengP.Fuel octane and volatility effects on the stochastic pre-ignition behavior of a 2.0L gasoline turbocharged DI engine. SAE Int J Fuels Lubr2014; 7(2): 379–389.
7.
CraigAWarkinsJAravelliK, et al. Low cost LEV-III, tier-III emission solutions with particulate control using advanced catalysts and substrates. SAE Int J Engines2016; 9(2): 1276–1288.
8.
JohnsonT.Vehicular emissions in review. SAE Int J Engines2016; 9(2): 1258–1275.
9.
CARB. California Air Resources Board Staff current assessment of the technical feasibility of lower NOx standards associated test procedures for 2022 And subsequent model year medium-duty and heavy-duty diesel engines. https://content.govdelivery.com/accounts/CARB/bulletins/23f72f1 (accessed 20 February 2020).
10.
PosadaFBadshahHRodriguezF.In-use NOx emissions and compliance evaluation for modern heavy-duty vehicles in Europe and the United States. Retrieved from The International Council on Clean Transportation, https://theicct.org/publications/inuse-nox-hdvs-us-eu (2020, accessed 1 June 2020).
11.
NeelyGSharpCRaoS.CARB low NOx stage 3 program– modified engine calibration and hardware evaluations. SAE technical paper 2020-01-0318, 2020.
12.
RaoSSarlashkarJRengarajanS, et al. A controls overview on achieving ultra-low NOx. SAE technical paper 2020-01-1404, 2020.
BoronatVSplitterDDal Forno ChuahyF.Achieving diesel-like efficiency in a high stroke-to-bore ratio DISI engine under stoichiometric operation. SAE technical paper 2020-01-0293, 2020.
15.
CarisDFNelsonEE.A new look at high compression engines. SAE technical paper no. 590015, 1959.
16.
SzybistJFosterMMooreWConferK. Investigation of knock limited compression ratio of ethanol gasoline blends. SAE technical paper 2010-01-0619, 2010.
17.
SplitterDASzybistJP. Experimental investigation of spark-ignited combustion with high-octane biofuels and EGR. 2. Fuel and EGR effects on knock-limited load and speed. Energy Fuels2014; 28(2): 1432–1445.
18.
SplitterDASzybistJP. Experimental investigation of spark-ignited combustion with high-octane biofuels and EGR. 1. Engine load range and downsize downspeed opportunity. Energy Fuels2014; 28(2): 1418–1431.
19.
SplitterDASzybistJP.Intermediate alcohol-gasoline blends, fuels for enabling increased engine efficiency and powertrain possibilities. SAE Int J Fuels Lubr2014; 7(1): 29–47.
20.
CavinaNSivieroCSugliaR.Residual gas fraction estimation: application to a GDI engine with variable timing and EGR. SAE technical paper 2004-01-2943, 2004.
21.
WoschniG.A universally applicable equation for the instantaneous heat transfer coefficient in the internal combustion engine. SAE Trans1967; 76: 3065.
22.
GatowskiJABallesENChunKMNelsonFEEkchianJAHeywoodJB.Heat release analysis of engine pressure data. SAE Trans1984(1): 961–977.
23.
TunestålP.TDC offset estimation from motored cylinder pressure data based on heat release shaping. Oil Gas Sci Technol2011; 66(4): 705–716.
24.
HeywoodJB.Internal combustion engine fundamentals. New York: McGraw-Hill Education, 2018.
25.
PetersN.The turbulent burning velocity for large-scale and small-scale turbulence. J Fluid Mech1999; 384: 107–132.
26.
EnauxBGranetVVermorelO, et al. LES study of cycle-to-cycle variations in a spark ignition engine. Proc Combust Inst2011; 33(2): 3115–3122.
27.
ZhaoLAbdul MoizASomS, et al. Examining the role of flame topologies and in-cylinder flow fields on cyclic variability in spark-ignited engines using large-eddy simulation. Int J Eng Res2017; 19(8): 886–904.
28.
Mounaïm-RousselleCLandryLHalterFFoucherF.Experimental characteristics of turbulent premixed flame in a boosted Spark-Ignition engine. Proc Combust Inst2013; 34(2): 2941–2949.
29.
KitagawaTTogamiYHaradaKOgawaT.Effects of pressure on unstretched laminar burning velocity, Markstein length and cellularity of propagating spherical laminar flames. Trans Jpn Soc Mech Eng B2004; 70: 2197–2204.
30.
GalmicheBHalterFFoucherF.Effects of high pressure, high temperature and dilution on laminar burning velocities and Markstein lengths of iso-octane/air mixtures. Combust Flame2012; 159: 3286–3299.
31.
MooreWFosterMLaiM-CXieX-BZhengYMatsumotoA. Charge motion benefits of valve deactivation to reduce fuel consumption and emissions in a GDi, VVA engine. SAE technical paper, 2011-01-1221, 2011.
32.
SabathilDKoenigsteinASchaffnerFritzscheJDoehlerA. The influence of DISI engine operating parameters on particle number emissions. SAE technical paper 2011-01-0143, 2011.
33.
AlgerTGingrichJKhalekIAMangoldB.The role of EGR in PM emissions from gasoline engines. SAE Int J Fuels Lubr2010; 3(1): 85–98.
34.
ZhangZWangTJiaMWeiQMengXShuG.Combustion and particle number emissions of a direct injection spark ignition engine operating on ethanol/gasoline and n-butanol/gasoline blends with exhaust gas recirculation. Fuel2014; 130: 177–188.
35.
StoreyJMELewisSASzybistJP, et al. Novel characterization of GDI engine exhaust for gasoline and mid-level gasoline-alcohol blends. SAE Int J Fuels Lubr2014; 7: 1–8.
36.
StoreyJMEBaroneTLThomasJFHuffSP. Exhaust particle characterization for lean and stoichiometric DI vehicles operating on ethanol-gasoline blends. SAE technical paper series 2012-01-0437, 2012.
KoczakJBoehmanABrusstarM.Particulate emissions in GDI vehicle transients: an examination of FTP, HWFET, and US06 measurements. SAE technical paper 2016-01-0992, 2016.
39.
DelgadoOLutseyN.The US SuperTruck program. Washington, DC: The international Council on Clean Transportation, 2014.
40.
ReinhartTE.Commercial medium-and heavy-duty truck fuel efficiency technology study-Report# 1, 2015. (No. DOT HS 812 146). The united States Department of Transportation, National Highway and Safety Administration.
41.
RengarajanSLiuZLerinCStetterJNarangVLanaC. LPG direct injection engine for medium duty trucks. SAE technical paper 2020-01-5008, 2020.
