Implementing variable valve actuation on a diesel engine at high-speed idle operation for improved aftertreatment warm-up

Abstract

Aftertreatment thermal management is critical for regulating emissions in modern diesel engines. Elevated engine-out temperatures and mass flows are effective at increasing the temperature of an aftertreatment system to enable efficient emission reduction. In this effort, experiments and analysis demonstrated that increasing the idle speed, while maintaining the same idle load, enables improved aftertreatment “warm-up” performance with engine-out NOx and particulate matter levels no higher than a state-of-the-art thermal calibration at conventional idle operation (800 rpm and 1.3 bar brake mean effective pressure). Elevated idle speeds of 1000 and 1200 rpm, compared to conventional idle at 800 rpm, realized 31%–51% increase in exhaust flow and 25 °C–40 °C increase in engine-out temperature, respectively. This study also demonstrated additional engine-out temperature benefits at all three idle speeds considered (800, 1000, and 1200 rpm, without compromising the exhaust flow rates or emissions, by modulating the exhaust valve opening timing. Early exhaust valve opening realizes up to ~51% increase in exhaust flow and 50 °C increase in engine-out temperature relative to conventional idle operation by forcing the engine to work harder via an early blowdown of the exhaust gas. This early blowdown of exhaust gas also reduces the time available for particulate matter oxidization, effectively limiting the ability to elevate engine-out temperatures for the early exhaust valve opening strategy. Alternatively, late exhaust valve opening realizes up to ~51% increase in exhaust flow and 91 °C increase in engine-out temperature relative to conventional idle operation by forcing the engine to work harder to pump in-cylinder gases across a smaller exhaust valve opening. In short, this study demonstrates how increased idle speeds, and exhaust valve opening modulation, individually or combined, can be used to significantly increase the “warm-up” rate of an aftertreatment system.