Numerical study of combustion characteristics and emissions of a diesel–methane dual-fuel engine for a wide range of injection timings

Abstract

Computational fluid dynamics simulations are performed to investigate the combustion and emission characteristics of a diesel/natural gas dual-fuel engine. The computational fluid dynamics model is validated against experimental measurements of cylinder pressure, heat release rate, and exhaust emissions from a single-cylinder research engine. The model predictions of in-cylinder diesel spray distribution and location of diesel ignition sites are related to the behavior observed in measured and predicted heat release rate and emissions. Various distributions of diesel fuel inside the combustion chamber are obtained by modifying the diesel injection timing and the spray included angle. Model predictions suggest that the distribution of diesel fuel in the combustion chamber has a significant impact on the characteristics of heat release rate, explaining experimental observations. Regimes of combustion in the dual-fuel engine are identified. Turbulent flame speed calculations, premixed turbulent combustion regime diagram analysis, and high-temperature front propagation speed estimation indicated that the dual-fuel combustion in this engine was supported by successive local auto-ignition and not by turbulent flame propagation.

Keywords

Diesel/natural gas dual-fuel engine CFD wide range of injection timings heat release rate emissions in-cylinder analysis spray distribution ignition spots regimes of combustion

Get full access to this article

View all access options for this article.

References

Reitz

RD.

Directions in internal combustion engine research. Combust Flame 2013; 160(1): 1–8.

Shah

Johnson

Miller

Cocker

III . Emission rates of regulated pollutants from on-road heavy-duty diesel vehicles. Atmos Environ 2006; 40: 147–153.

Korakianitis

Namasivayam

Crookes

RJ.

Natural-gas fueled spark-ignition (SI) and compression-ignition (CI) engine performance and emissions. Prog Energ Combust 2011; 37(1): 89–112.

Carlucci

de Risi

Laforgia

Naccarato

Experimental investigation and combustion analysis of a direct injection dual-fuel diesel–natural gas engine. Energy 2008; 33(2): 256–263.

Karim

. Combustion in gas-fueled compression ignition engines of the dual fuel type. J Eng Gas Turb Power, 2003; 125: 827–836. doi:10.1115/1.1581894.

Papagiannakis

Hountalas

DT.

Combustion and exhaust emission characteristics of a dual fuel compression ignition engine operated with pilot diesel fuel and natural gas. Energ Convers Manage 2004; 45(18–19): 2971–2987.

Wei

Geng

A review on natural gas/diesel dual fuel combustion, emissions and performance. Fuel Process Technol 2016; 142: 264–278.

Sun

Liu

Zeng

Yang

Hang

ZH.

Combustion performance and stability of a dual-fuel diesel–natural-gas engine. Proc IMechE, Part D: J Automobile Engineering 2015; 229(2): 235–246.

Liu

Yang

Wang

Ouyang

Hao

Effects of pilot fuel quantity on the emissions characteristics of a CNG/diesel dual fuel engine with optimized pilot injection timing. Appl Energ 2013; 110: 201–206.

10.

Singh

Krishnan

Srinivasan

Midkiff

Bell

SR.

Effect of pilot injection timing, pilot quantity and intake charge conditions on performance and emissions for an advanced low-pilot-ignited natural gas engine. Int J Engine Res 2004; 5(4): 329–348.

11.

Guerry

Raihan

Srinivasan

Krishnan

Sohail

Injection timing effects on partially premixed diesel–methane dual fuel low temperature combustion. Appl Energ 2016; 162: 99–113.

12.

Cameretti

Tuccillo

DeSimio

Iannaccone

Ciaravola

A numerical and experimental study of dual fuel diesel engine for different injection timings. Appl Therm Eng 2016; 101: 630–638.

13.

Hountalas

Papagiannakis

. A simulation model for the combustion process of natural gas engines with pilot diesel fuel as an ignition source. SAE technical paper 2001-01-1245, 2001.

14.

Zhang

Kong

Reitz

. Modeling and simulation of a dual fuel (diesel/natural gas) engine with multidimensional CFD. SAE technical paper 2003-01-0755, 2003.

15.

Singh

Kong

S-C

Reitz

Krishnan

Midkiff

. Modeling and experiments of dual-fuel engine combustion and emissions. SAE technical paper 2004-01-0092, 2004.

16.

Singh

Liang

Kong

S-C

Reitz

RD.

Development of a flame propagation model for dual-fuel partially premixed compression ignition engines. Int J Engine Res 2006; 7(1): 65–75.

17.

Singh

Reitz

Wickman

Stanton

Tan

. Development of a hybrid, auto-ignition/flame-propagation model and validation against engine experiments and flame liftoff. SAE technical paper 2007-01-0171, 2007.

18.

Talekar

Lai

M-C

Zeng

Yang

Jansons

. Simulation of dual-fuel-CI and single-fuel-SI engine combustion fueled with CNG. SAE technical paper 2016-01-0789, 2016.

19.

Richards

Senecal

Pomraning

. CONVERGE (v2.2), Convergent Science, Inc., Madison, WI, 2015.

20.

Namazian

Heywood

JB.

Flow in the piston-cylinder-ring crevices of a spark-ignition engine: effect on hydrocarbon emissions, efficiency and power. SAE technical paper 820088, 1982.

21.

Issa

RI.

Solution of the implicitly discretised fluid flow equations by operator-splitting. J Comput Phys 1986; 62(1): 40–65.

22.

Launder

Spalding

DB.

The numerical computation of turbulent flows. Comput Method Appl M 1974; 3(2): 269–289.

23.

Schmidt

Rutland

CJ.

A new droplet collision algorithm. J Comput Phys 2000; 164: 62–80.

24.

Orourke

Amsden

. A spray/wall interaction submodel for the KIVA-3 wall film model. SAE technical paper 2000-01-0271, 2000.

25.

Smith

Golden

Frenklach

Moriarty

Eiteneer

Goldenberg

, et al. GRI-Mech 3.0. http://www.me.berkeley.edu/gri_mech/

26.

Pomraning

Richards

Senecal

PK.

Modeling turbulent combustion using a RANS model, detailed chemistry, and adaptive mesh refinement. SAE technical paper 2014-01-1116, 2014.

27.

Aggarwal

SK.

Two-stage ignition and NTC phenomenon in diesel engines. Fuel 2015; 144: 188–196.

28.

Peters

Turbulent combustion. Cambridge: Cambridge University Press, 2009.

29.

Lumley

JL.

Engines: an introduction: using the Stanford engine simulation program of W.C. Reynolds with John L. Lumley. Cambridge: Cambridge University Press, 1999.