A series of finite element (FE) models of ground floor slab behaviour has been developed and validated against in situ data from site instrumentations. Good agreement was obtained for thermal flow models, and the negative impact of air movement over the top of the slab has been highlighted. Plane stress models of slabs exposed to uniform and differential thermal gradients representing hydration and shrinkage effects demonstrated that the stresses resulting from frictional restraint are significantly less than those caused by warping restraint, even though the latter are currently not considered in design.
PetterssonD.Stresses in concrete structures from ground restraint. PhD thesis, Department of Structural Engineering, Lund Institute of Technology, Sweden, 1998, 113 pp.
ReesS. W.LloydR. M.ThomasH. R.A numerical simulation of measured transient heat transfer through a concrete ground floor slab and underlying substrateInt. J. Numer. Meth. in Heat and Fluid Flow, 1995, 5, 669–683.
4.
KhanA.A.CookW. D.MitchellD.Thermal properties and transient thermal analysis of structural members during hydrationACI Mater. J., May-June 1998, 95 (3), 293–303.
5.
MirambellE.Temperature and stress distributions in plain concrete pavements under thermal and mechanical loads. In 2nd International Workshop onTheoretical Design of Concrete Pavements (Ed. PIARC Committee on Concrete Roads, Cembureau), 1st edition, Centre ROW, Ede, 1990, Vol. 5, pp. 121–135.
6.
AyotteÉ.MassicoteB.HoudeJ.GocevskiV.Modelling the thermal stresses at early ages in a concrete monolithACI Mater. J/, November-December 1997, 94 (6), 577–587.
7.
ThelanderssonS.AlemoJ.NagyA.Cracking in concrete structures due to imposed strains with regard to design of reinforcementMater, and Struct., August-September 1998, 31 (211), 442–450.
8.
ByforsJ.Plain Concrete at Early Ages, 1980, pp. (Swedish Council for Building Research, Lund University, Lund, Sweden).
9.
CIBSE Guide, Volume A—Design Data, 6th edition, 1999 (The Chartered Institute of Building Services Engineers, London).
10.
NevilleA. M.Properties of Concrete, 4th edition, 1995, 844 pp (Longman Group Limited, Harlow).
11.
FaraggiV.JofrC.KraemerC.Combined effect of traffic loads and thermal gradients on concrete pavement design. Transportation Research Record 1136, 1987, pp. 108–118.
12.
van BreugelK.Simulation model for development of properties of early-age concrete. In Proceedings of 2nd International RILEM/CEB Symposium onQuality Control of Concrete Structures (Eds TaerweL.LambotteH.), Ghent, June 1991, RILEM Proceedings 14, pp. 139–151 (E & FN Spon, London).
13.
BishopJ. W.AustinS. A.RobinsP. J.Industrial concrete ground floors: Current knowledge and practiceICE Struct, and Buildings, 2002, in preparation.
14.
TomlinsonJ.Temperature variations and consequent stresses produced by daily and seasonal temperature cycles in concrete slabsConcr. and Constr. Engng, June 1940, 35 (6), 298–307.
15.
de BorstR.van den BoogardA. H.Finite element modeling of deformation and cracking in early-age conreteASCEJ. Engng Mechanics, 1994, 120 (12), 2519–2534.
16.
TurtonC. D.Discussion on paper ‘Influence of mix proportions and construction operations on plastic shrinkage cracking in thin slabs’ by Shaeles et al. (1988)ACI Mater. J., 1989, 86, 531–532.
17.
AustinS. A.RobinsP. J.BishopJ. W.Hygral effects in industrial ground floorsCement and Concrete Res., 2002, in preparation.
18.
ACI Committee 207: Mass concrete. Technical report ACI 207–1R-87, American Concrete Institute, Farmington Hills, Michigan, 1987, 44 pp.
19.
de SchutterG.TaerweL.Degree of hydration based description of mechanical properties of early age concreteMater, and Struct., 1996, 29, 335–344.
20.
KimS.-M.WonM. C.McCulloughB. F.Three dimensional nonlinear finite element analysis of continuously reinforced concrete pavements. Centre for Transportation Research. The University of Texas at Austin, Austin, Texas, 2000, 75 pp.
21.
TellerL. W.SutherlandE. C.The structural design of concrete pavements. Part 5: An experimental study of the Westergaard analysis of stress conditions in concrete pavements of uniform thicknessPubl. Roads, 1943, 23 (8).
22.
LachemiM.AïtcinP.-C.Influence of ambient and fresh concrete temperatures on the maximum temperature and thermal gradient in a high performance concrete structureACI Mater. J., March-April 1997, 94 (2), 102–110.
23.
TomlinsonJ.Temperature variations and consequent stresses produced by daily and seasonal temperature cycles in concrete slabsConcr. and Constr. Engng, July 1940, 35 (7), 352–360.
24.
CUR 36 (Draft). Design, calculation and detailing of industrial floors in structural concrete. CUR Foundation, Ak Gouda, 1994, 69 pp.
25.
TR34: Concrete Industrial Ground Floors-A Guide to their Design and Construction, 2nd edition, 1994, 145 pp. (The Concrete Society, Slough).
26.
LosbergA.Pavements and slabs on grade with structurally active reinforcementACI J., 1978, 75 (66), 647–657.
27.
RollingsR. S.Curling failure of steel-fiber-reinforced concrete slabsJ. Performance Constructed Facilities, February 1993, 7 (1), 3–19.
28.
LeonardsG. A.HarrM. E.Analysis of concrete slabs on groundASCE J. Soil Mechanics, 1958, SM3, 35–58.
29.
KiamcoC.A structural look at slabs on gradeConcr. Int., July 1997, 19 (7), 45–49.
30.
de WitteF. C. (Ed.) Diana Finite Element Analysis, Online User's Manual—Release 7.2, 1999 (TNO Building and Construction Research, Dept of Engineering, Mechanics and IT, Delft, The Netherlands).
31.
BazantZ. P.BawejaS.Creep and shrinkage prediction model for analysis and design of concrete structures—model B3Mater, and Struct., 1995, 28 (28), 357–365.
32.
BazantZ. P.BawejaS.Justification and refinements of model B3 for concrete creep and shrinkage. I Statistics and sensitivityMater, and Struct., 1995, 28, 415–430.
33.
BazantZ. P.BawejaS.Justification and refinements of model B3 for conrete creep and shrinkage. 2 Updating and theoretical basisMater, and Struct., 1995, 28, 488–495.
