This study examined the influence of heat recovery ventilators (HRVs) on energy savings and indoor air quality (IAQ) in high-rise residential buildings. Field measurements were performed in four residential units, which were validated by computer simulations and estimated the total annual energy consumption. The operation schedules for HRVs were determined by a survey of residents. Field measurement results indicate that HRVs could effectively improve IAQ and afford effective energy savings. The indoor concentrations of formaldehyde were reduced by 54.6% after HRVs were operated for 24 h. The initial concentration was reduced by 82% after 168 h. Toluene was the dominant volatile organic compounds (VOCs) in the indoor air. Its initial concentration was reduced by 50% and other VOCs were also reduced by 40.1% to 53.1% after HRVs were operated. Annual energy savings of up to 20.26% were predicted when HRVs were operated for 24 h continuously, exchanging sensible and latent heat. HRVs could save energy more effectively in winter than in summer due to the greater temperature difference between outdoor and indoor air. Based on the preferred operation schedules of homes surveyed, an annual energy savings could be as high as 8.52%.
KimSSongK: Determining photosensor conditions of a daylight dimming control system using different double-skin envelope configurations: Indoor Built Environ2007;16:411–425.
2.
ChoiASongKKimY: The characteristics of photosensor and electronic dimming in daylight responsive dimming systems: Build Environ2005;40:39–50.
3.
YuCWFKimJT: Building pathology, investigation of sick buildings – VOC emissions: Indoor Built Environ2010;19(1):30–39.
4.
YuCWFKimJT: Building environmental assessment schemes for rating of IAQ in sustainable buildings: Indoor Built Environ2011;20(1):5–15.
5.
WangSSunZSunYZhuN: Online optimal ventilation control of building systems: Indoor Built Environ2011;20(1):129–136.
6.
YikFWHLunYF: Energy saving by utilizing natural ventilation in public housing in Hong Kong: Indoor Built Environ2010:19(1):73–87.
7.
LazzarinRGasparellaA: Technical and economical analysis of heat recovery in building ventilation systems: Appl Therm Eng1998; 18:47–67.
8.
ZhangYJiangYZhangLDengYJinZ: Analysis of thermal performance and energy savings of membrane based heat recovery ventilator: Energy2000;25:515–527.
9.
ZhouYWuJWangR: Performance of energy recovery ventilator with various weather and temperature set-points: Energy Build2007;39:1202–1210.
10.
FehrmMReinersWUngemachM: Exhaust air heat recovery in buildings: Int J Refrigeration2002; 25:439–449.
11.
RouletCHeidtFForadiniFPibiriM: Real heat recovery with air handling units: Energy Build2001;33:495–502.
12.
LazzarinRGasparellaA: Technical and economical analysis of heat recovery in building ventilation systems: Appl Therm Eng1998;18:47–67.
13.
ZhongKKangY: Applicability of air-to-air heat recovery ventilators in China: Appl Therm Eng2009;29:830–840.
14.
GageAyresAxon: The use of heat pumps to induce airflow on hot days in otherwise passive ventilation systems- a zonal modeling approach: Indoor Built Environ2000;9(3-4):127–142.
15.
BrahamGD: Mechanical ventilation and fabric thermal storage: Indoor Built Environ2000;9(2):102–110.
16.
BerryJ: Super-efficient mechanical ventilation: Indoor Built Environ2000;9(2):87–96.
17.
RasouliMSimonsonCBesantR: Applicability and optimum control strategy of energy recovery ventilators in different climatic conditions: Energy Build2010;42:1376–1385.
18.
Sun Z, Wang S, Zhu N: Model-based optimal control of outdoor air flow rate of an air-conditioning system with primary air-handling unit: Indoor Built Environ 1420326X11411511, first published on July 18, 2011, doi:10.1177/1420326X11411511.
19.
LiuJLiWWangB: Efficiency of energy recovery ventilator with various weathers and its energy saving performance in a residential apartment: Energy Build2010;42:43–49.
20.
MariskTJohnsonR: Use of Simulink to evaluate the air-quality and energy performance of HRV-equiped residences in Fairbanks, Alaska: Energy Build2008;40:1605–1613.
21.
AwbiHAllwinkleS: Domestic ventilation with heat recovery to improve indoor air quality: Energy Build1986;9:305–312.
22.
LavergeJBosscheNHeijmansNJanssensA: Energy saving potential and repercussions on indoor air quality of demand controlled residential ventilation strategies: Build Environ2011;46:1497–1503.
23.
RouletCHeidtFForadiniFPibiriM: Real heat recovery with air handling units: Energy Build2001;33:495–502.
24.
JuodisE: Extracted ventilation air heat recovery efficiency as a function of a building’s thermal properties: Energy Build2006;38:568–573.
25.
KalameesT: Indoor climate conditions and ventilation performance in Estonian lightweight detached houses: Indoor Built Environ2006;15(6):555–569.
26.
BarringerCG: Effect of residential air to air heat and moisture exchangers on indoor humidity: ASHRAE Trans1989;Part 2:464–481.
27.
KtstlerKRCusslerEL: Membrane modules for building ventilation: Inst Chem Eng Trans IChemE2002;80:53–64.
28.
BaeCChunJ: Research on seasonal indoor thermal environment and residents’ control behavior of cooling and heating systems in Korea: Build Environ2009;44:2300–2307.
29.
SongG: Buttock response to contact with finishing materials over the ONDOL floor heating system in Korea: Energy Build2005;37:65–75.
30.
KimSKHongHKimSKimJT: Method and analysis of a dynamic simulation of ondol heating: Indoor Built Environ2011;20(1):112-119.
31.
KimSLeeDHongH: An energy saving technique using ondol heating schedule control of housing units in Korea: Indoor Built Environ2010;19(1):88–93.
32.
ANSI-ASHRAE Standard 55-2004: Thermal Conditions for Human Occupancy. Atlanta, GA, ANSI/ASHRAE, 2004.
33.
National Building Codes of Korea: Standard Codes for Building Facility and Equipment. Article 328, Korea, 2003.
34.
ANSI/ASHRAE Standard 62.2-2003: Ventilation and Acceptable Indoor Air Quality in Low-Rise Residential Buildings. Atlanta, GA, ASHRAE, 2003.
35.
CR 1752:1998: Ventilation for Buildings; Design Criteria for the Indoor Environment. CEN/TC 156 - Ventilation for Buildings. Brussels, European Committee for Standardisation (CEN), 1998.
36.
NHS Estates: Ventilation in Healthcare Premises: Design Considerations. Health Technical Memorandum 2025, London. Norwich, The Stationery Office, 1994.
37.
Chinese National Standard GB 50176-93: Building Design Code for Civil Buildings. Beijing, Chinese Plan Publication House, 1993.
38.
National Building Code of Korea: Standard Codes for Building Facility and Equipment. Article 11, Korea, 2006.
39.
ASTM E741-95, Standard Test Method for Determining Air Change in a Single Zone by Means of a Tracer Gas Dilution. Philadelphia, American Society for Testing and Materials, 2006.
40.
PersilyADolsW: The relation of CO2 concentration to office building ventilation, air change rate and airtightness in buildings; in ShermanHM (ed): Air Change Rate and Airtightness in Buildings: ASTM STP 1067, Philadelphia, American Society for Testing and Materials, 1990, pp. 77–92.
41.
ASHRAE: 2009ASHRAE Handbook-Fundamentals. Atlanta, GA, American Society of Heating Refrigerating and Air-Conditioning Engineers, Inc., 2009.
42.
ChuahYKFuYMHungCCTsengPC: Concentration variation of pollutants in a work week period of an office: Build Environ1997;32:535–540.
43.
CheongKW: Airflow measurements for balancing of air distribution system-tracer gas technique as an alternative: Build Environ2001;36:955–964.
44.
TRACE 700: User’s Manual, Trane 2001.
45.
HolnessG: Building information modeling-Gaining momentum: ASHRAE J2008;28–40.
46.
CrawleyDHandJKummertMGriffithB: Contrasting the capabilities of building energy performance simulation programs: Build Environ2008;43:661–673.
47.
Standard Weather Data in Korea, The Society of Air-conditioning and Refrigerating Engineering of Korea, Vol. 2, 1996.
48.
National Institute of Environmental Research: Recommended guidelines for indoor air quality in newly-constructed apartment houses, Codes for management of indoor air quality. Article 9, Environment ministry, Korea, 2008.
49.
FauchouxMSimonsonCTorviD: The effect of energy recovery on perceived air quality, energy consumption, and the economics of an office building: ASHRAE Trans2001;113(2):437–449.
50.
SimonsonCShangWBesantR: Part-load performance of energy wheels. Part I. Wheel speed control: ASHRAE Trans2000;106(1):286–300.
