Experimental study and numerical simulation of reinforced concrete walls with lightened blocks connected with bolts

Abstract

To verify the feasibility and mechanical properties of assembled composite walls, three assembled composite walls were designed. Two bolted connection specimens in horizontal joints were tested under low-cycle reversed loading and monotonic loading, respectively. Then, the failure mechanism, hysteretic behaviour, ductility, energy dissipation capacity, slip and stress distribution of the connectors were studied. A specimen with grouting sleeve connection was tested under low-cycle reversed loading as a contrast specimen. In addition, a specimen with bolted connection under monotonic loading was simulated by the finite element method to study the effects on structural performance of the connectors and walls. The results show that the bolted connection is feasible, and compared with the grouting sleeve connection, the bearing capacity of the bolted connection specimen decreases by 17%, the displacement ductility coefficient increases by 52% and the cumulative energy consumption increases by 62%. Slippage between the connectors and the wallboard occurs mainly between the yield point and the peak point of the specimens. With the increase in plate thickness, the bearing capacity and initial stiffness increased, but there was no obvious effect on the appearance of the slip section. The larger the bolt diameter, the later the slip section forms. However, the bolt diameter does not have an obvious effect on the bearing capacity of the specimens.