Influence of local turbulent flow on the performance of a mixed-lubrication bearing

Abstract

For some large heavy load bearings, asperity contact may occur in the area near the minimum film thickness. However, in the remaining area, the liquid film may be much thicker, and thus turbulence develops locally. To investigate the influence of local turbulent flow on the performance of a mixed-lubrication bearing, in this paper, the bearing is divided into a mixed-lubrication region and a pure hydrodynamic lubrication region according to the film thickness ratio. The liquid in the mixed-lubrication region is calculated using the average Reynolds equation, and the generalized Reynolds equation considering turbulence is used to describe the pure hydrodynamic lubrication region. The calculation procedure is established and a journal bearing is simulated. The results show that local turbulence influences the bearing performance, and it remarkably influences the friction coefficient.

Keywords

Heavy load bearing local turbulence mixed-lubrication

Get full access to this article

View all access options for this article.

References

Litwin

. Water-lubricated bearings of ship propeller shafts-problems, experimental tests and theoretical investigations. Pol Marit Res2009; 16: 42–50.

Litwin

. Experimental research on water-lubricated marine stern bearings on conditions of improper and cooling causing rapid bush wear. Tribol Int2016; 95: 449–455.

Pai

. Stability of four-axial and six-axial grooved water-lubricated journal bearings under dynamic load. Proc IMechE, Part J: J Engineering Tribology2008; 222: 683–691.

Litwin

. Influence of surface roughness topography on properties of water-lubricated polymer bearing: experimental research. Tribol Trans2011; 54: 351–361.

Mallya

Shenoy

Pai

. Steady state characteristics of misaligned multiple axial groove water-lubricated journal bearing. Proc IMechE, Part J: J Engineering Tribology2014; 229: 712–722.

Kraker

Ostayen

RAJV

Rixen

. Calculation of Stribeck curves for (water) lubricated journal bearings. Tribol Int2007; 40: 459–469.

Zou

et al.

Mixed-lubrication analysis of marine stern tube bearing considering bending deformation of stern shaft and cavitation. Tribol Int2014; 73: 108–116.

Han

Xiong

Wang

et al.

A new singularity treatment approach for journal-bearing mixed lubrication modeled by the finite difference method with a herringbone mesh. ASME J Tribol2016; 138: 011704.

Constantinescu

. On turbulent lubrication. Proc Instn Mech Engrs1959; 173: 81–90.

10.

Constantinescu

. Analysis of bearings operating in turbulent regime. ASME J Fluids Eng1962; 84: 139–151.

11.

Pan

CHT

. A linearized turbulent lubrication theory. ASME J Fluids Eng1965; 87: 675–688.

12.

Elrod

. A theory for turbulent films and its application to bearings. ASME J Tribol1967; 86: 346–362.

13.

Bouard

Fillon

Frene

. Comparison between three turbulent models - application to thermohydrodynamic performances of tilting-pad journal bearings. Tribol Int1996; 29: 11–18.

14.

Bou-Said

Nicolas

. Effects of misalignment on static and dynamic characteristics of hybrid bearings. Tribol Trans1992; 35: 325–331.

15.

Frene

. Tapered land thrust bearing operating in both laminar and turbulent regimes. Tribol Trans1978; 21: 243–249.

16.

Braunetiere

. A modified turbulence model forlow Reynolds numbers: application to hydrostatic seals. ASME Trans J Tribol2005; 127: 130–140.

17.

Shenoy

Pai

. Theoretical investigations on the performance of an externally adjustable fluid-film bearing including misalignment and turbulence effects. Tribol Int2009; 42: 1088–1100.

18.

Susilowati, Tauviqirrahman M, Jamari J, et al. A comparative study of finite journal bearing in laminar and turbulent regimes using CFD (computational fluid dynamic). In: MATEC web of conferences, vol. 58, 2016.

19.

Zhang

Liu

Wang

et al.

Approximate solution to load-carrying capacity of a turbulent flow sliding bearing's oil film. J Vib Shock2014; 33: 181–186.

20.

Mallya

Shenoy

Pai

. Static characteristics of misaligned multiple axial groove water-lubricated bearing in the turbulent regime. Proc IMechE, Part J: J Engineering Tribology2017; 231: 385–398.

21.

Patir

Cheng

. An average flow model for determining effects of three-dimensional roughness on partial hydrodynamic lubrication. J Lubr Technol1978; 100: 12–17.

22.

Greenwood

Tripp

. The contact of two nominally flat rough surfaces. Proc Instn Mech Engrs1970; 185: 625–634.

23.

Sun

Gui

. Hydrodynamic lubrication analysis of journal bearing considering misalignment caused by shaft deformation. Tribol Int2004; 37: 841–848.

24.

et al.

Mixed lubrication analysis of a ship stern bearing. J Ship Mech2014; 18: 973–981.